diff options
Diffstat (limited to 'drivers/spi/spi.c')
| -rw-r--r-- | drivers/spi/spi.c | 57 |
1 files changed, 47 insertions, 10 deletions
diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c index ccca3a7409fa..dc4d19bd84b0 100644 --- a/drivers/spi/spi.c +++ b/drivers/spi/spi.c @@ -810,7 +810,8 @@ static void spi_set_cs(struct spi_device *spi, bool enable) spi->controller->last_cs_enable = enable; spi->controller->last_cs_mode_high = spi->mode & SPI_CS_HIGH; - if (!spi->controller->set_cs_timing) { + if (spi->cs_gpiod || gpio_is_valid(spi->cs_gpio) || + !spi->controller->set_cs_timing) { if (enable1) spi_delay_exec(&spi->controller->cs_setup, NULL); else @@ -841,7 +842,8 @@ static void spi_set_cs(struct spi_device *spi, bool enable) spi->controller->set_cs(spi, !enable); } - if (!spi->controller->set_cs_timing) { + if (spi->cs_gpiod || gpio_is_valid(spi->cs_gpio) || + !spi->controller->set_cs_timing) { if (!enable1) spi_delay_exec(&spi->controller->cs_inactive, NULL); } @@ -1945,6 +1947,9 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi, /* Device DUAL/QUAD mode */ if (!of_property_read_u32(nc, "spi-tx-bus-width", &value)) { switch (value) { + case 0: + spi->mode |= SPI_NO_TX; + break; case 1: break; case 2: @@ -1966,6 +1971,9 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi, if (!of_property_read_u32(nc, "spi-rx-bus-width", &value)) { switch (value) { + case 0: + spi->mode |= SPI_NO_RX; + break; case 1: break; case 2: @@ -3333,12 +3341,16 @@ int spi_setup(struct spi_device *spi) unsigned bad_bits, ugly_bits; int status; - /* check mode to prevent that DUAL and QUAD set at the same time + /* + * check mode to prevent that any two of DUAL, QUAD and NO_MOSI/MISO + * are set at the same time */ - if (((spi->mode & SPI_TX_DUAL) && (spi->mode & SPI_TX_QUAD)) || - ((spi->mode & SPI_RX_DUAL) && (spi->mode & SPI_RX_QUAD))) { + if ((hweight_long(spi->mode & + (SPI_TX_DUAL | SPI_TX_QUAD | SPI_NO_TX)) > 1) || + (hweight_long(spi->mode & + (SPI_RX_DUAL | SPI_RX_QUAD | SPI_NO_RX)) > 1)) { dev_err(&spi->dev, - "setup: can not select dual and quad at the same time\n"); + "setup: can not select any two of dual, quad and no-rx/tx at the same time\n"); return -EINVAL; } /* if it is SPI_3WIRE mode, DUAL and QUAD should be forbidden @@ -3352,7 +3364,8 @@ int spi_setup(struct spi_device *spi) * SPI_CS_WORD has a fallback software implementation, * so it is ignored here. */ - bad_bits = spi->mode & ~(spi->controller->mode_bits | SPI_CS_WORD); + bad_bits = spi->mode & ~(spi->controller->mode_bits | SPI_CS_WORD | + SPI_NO_TX | SPI_NO_RX); /* nothing prevents from working with active-high CS in case if it * is driven by GPIO. */ @@ -3449,11 +3462,31 @@ EXPORT_SYMBOL_GPL(spi_setup); int spi_set_cs_timing(struct spi_device *spi, struct spi_delay *setup, struct spi_delay *hold, struct spi_delay *inactive) { + struct device *parent = spi->controller->dev.parent; size_t len; + int status; + + if (spi->controller->set_cs_timing && + !(spi->cs_gpiod || gpio_is_valid(spi->cs_gpio))) { + if (spi->controller->auto_runtime_pm) { + status = pm_runtime_get_sync(parent); + if (status < 0) { + pm_runtime_put_noidle(parent); + dev_err(&spi->controller->dev, "Failed to power device: %d\n", + status); + return status; + } - if (spi->controller->set_cs_timing) - return spi->controller->set_cs_timing(spi, setup, hold, - inactive); + status = spi->controller->set_cs_timing(spi, setup, + hold, inactive); + pm_runtime_mark_last_busy(parent); + pm_runtime_put_autosuspend(parent); + return status; + } else { + return spi->controller->set_cs_timing(spi, setup, hold, + inactive); + } + } if ((setup && setup->unit == SPI_DELAY_UNIT_SCK) || (hold && hold->unit == SPI_DELAY_UNIT_SCK) || @@ -3615,6 +3648,8 @@ static int __spi_validate(struct spi_device *spi, struct spi_message *message) * 2. check tx/rx_nbits match the mode in spi_device */ if (xfer->tx_buf) { + if (spi->mode & SPI_NO_TX) + return -EINVAL; if (xfer->tx_nbits != SPI_NBITS_SINGLE && xfer->tx_nbits != SPI_NBITS_DUAL && xfer->tx_nbits != SPI_NBITS_QUAD) @@ -3628,6 +3663,8 @@ static int __spi_validate(struct spi_device *spi, struct spi_message *message) } /* check transfer rx_nbits */ if (xfer->rx_buf) { + if (spi->mode & SPI_NO_RX) + return -EINVAL; if (xfer->rx_nbits != SPI_NBITS_SINGLE && xfer->rx_nbits != SPI_NBITS_DUAL && xfer->rx_nbits != SPI_NBITS_QUAD) |