diff options
Diffstat (limited to 'drivers/net/wireless/ti/wlcore/conf.h')
| -rw-r--r-- | drivers/net/wireless/ti/wlcore/conf.h | 110 |
1 files changed, 87 insertions, 23 deletions
diff --git a/drivers/net/wireless/ti/wlcore/conf.h b/drivers/net/wireless/ti/wlcore/conf.h index 9e40760bafe1..2b96ff821341 100644 --- a/drivers/net/wireless/ti/wlcore/conf.h +++ b/drivers/net/wireless/ti/wlcore/conf.h @@ -57,20 +57,49 @@ enum { }; enum { - CONF_HW_RATE_INDEX_1MBPS = 0, - CONF_HW_RATE_INDEX_2MBPS = 1, - CONF_HW_RATE_INDEX_5_5MBPS = 2, - CONF_HW_RATE_INDEX_6MBPS = 3, - CONF_HW_RATE_INDEX_9MBPS = 4, - CONF_HW_RATE_INDEX_11MBPS = 5, - CONF_HW_RATE_INDEX_12MBPS = 6, - CONF_HW_RATE_INDEX_18MBPS = 7, - CONF_HW_RATE_INDEX_22MBPS = 8, - CONF_HW_RATE_INDEX_24MBPS = 9, - CONF_HW_RATE_INDEX_36MBPS = 10, - CONF_HW_RATE_INDEX_48MBPS = 11, - CONF_HW_RATE_INDEX_54MBPS = 12, - CONF_HW_RATE_INDEX_MAX = CONF_HW_RATE_INDEX_54MBPS, + CONF_HW_RATE_INDEX_1MBPS = 0, + CONF_HW_RATE_INDEX_2MBPS = 1, + CONF_HW_RATE_INDEX_5_5MBPS = 2, + CONF_HW_RATE_INDEX_11MBPS = 3, + CONF_HW_RATE_INDEX_6MBPS = 4, + CONF_HW_RATE_INDEX_9MBPS = 5, + CONF_HW_RATE_INDEX_12MBPS = 6, + CONF_HW_RATE_INDEX_18MBPS = 7, + CONF_HW_RATE_INDEX_24MBPS = 8, + CONF_HW_RATE_INDEX_36MBPS = 9, + CONF_HW_RATE_INDEX_48MBPS = 10, + CONF_HW_RATE_INDEX_54MBPS = 11, + CONF_HW_RATE_INDEX_MCS0 = 12, + CONF_HW_RATE_INDEX_MCS1 = 13, + CONF_HW_RATE_INDEX_MCS2 = 14, + CONF_HW_RATE_INDEX_MCS3 = 15, + CONF_HW_RATE_INDEX_MCS4 = 16, + CONF_HW_RATE_INDEX_MCS5 = 17, + CONF_HW_RATE_INDEX_MCS6 = 18, + CONF_HW_RATE_INDEX_MCS7 = 19, + CONF_HW_RATE_INDEX_MCS7_SGI = 20, + CONF_HW_RATE_INDEX_MCS0_40MHZ = 21, + CONF_HW_RATE_INDEX_MCS1_40MHZ = 22, + CONF_HW_RATE_INDEX_MCS2_40MHZ = 23, + CONF_HW_RATE_INDEX_MCS3_40MHZ = 24, + CONF_HW_RATE_INDEX_MCS4_40MHZ = 25, + CONF_HW_RATE_INDEX_MCS5_40MHZ = 26, + CONF_HW_RATE_INDEX_MCS6_40MHZ = 27, + CONF_HW_RATE_INDEX_MCS7_40MHZ = 28, + CONF_HW_RATE_INDEX_MCS7_40MHZ_SGI = 29, + + /* MCS8+ rates overlap with 40Mhz rates */ + CONF_HW_RATE_INDEX_MCS8 = 21, + CONF_HW_RATE_INDEX_MCS9 = 22, + CONF_HW_RATE_INDEX_MCS10 = 23, + CONF_HW_RATE_INDEX_MCS11 = 24, + CONF_HW_RATE_INDEX_MCS12 = 25, + CONF_HW_RATE_INDEX_MCS13 = 26, + CONF_HW_RATE_INDEX_MCS14 = 27, + CONF_HW_RATE_INDEX_MCS15 = 28, + CONF_HW_RATE_INDEX_MCS15_SGI = 29, + + CONF_HW_RATE_INDEX_MAX = CONF_HW_RATE_INDEX_MCS7_40MHZ_SGI, }; #define CONF_HW_RXTX_RATE_UNSUPPORTED 0xff @@ -415,11 +444,11 @@ struct conf_rx_settings { #define CONF_TX_RATE_MASK_BASIC_P2P CONF_HW_BIT_RATE_6MBPS /* - * Rates supported for data packets when operating as AP. Note the absence + * Rates supported for data packets when operating as STA/AP. Note the absence * of the 22Mbps rate. There is a FW limitation on 12 rates so we must drop * one. The rate dropped is not mandatory under any operating mode. */ -#define CONF_TX_AP_ENABLED_RATES (CONF_HW_BIT_RATE_1MBPS | \ +#define CONF_TX_ENABLED_RATES (CONF_HW_BIT_RATE_1MBPS | \ CONF_HW_BIT_RATE_2MBPS | CONF_HW_BIT_RATE_5_5MBPS | \ CONF_HW_BIT_RATE_6MBPS | CONF_HW_BIT_RATE_9MBPS | \ CONF_HW_BIT_RATE_11MBPS | CONF_HW_BIT_RATE_12MBPS | \ @@ -677,6 +706,18 @@ struct conf_tx_settings { /* Time in ms for Tx watchdog timer to expire */ u32 tx_watchdog_timeout; + + /* + * when a slow link has this much packets pending, it becomes a low + * priority link, scheduling-wise + */ + u8 slow_link_thold; + + /* + * when a fast link has this much packets pending, it becomes a low + * priority link, scheduling-wise + */ + u8 fast_link_thold; } __packed; enum { @@ -1047,6 +1088,7 @@ struct conf_roam_trigger_settings { struct conf_scan_settings { /* * The minimum time to wait on each channel for active scans + * This value will be used whenever there's a connected interface. * * Range: u32 tu/1000 */ @@ -1054,24 +1096,37 @@ struct conf_scan_settings { /* * The maximum time to wait on each channel for active scans + * This value will be currently used whenever there's a + * connected interface. It shouldn't exceed 30000 (~30ms) to avoid + * possible interference of voip traffic going on while scanning. * * Range: u32 tu/1000 */ u32 max_dwell_time_active; - /* - * The minimum time to wait on each channel for passive scans + /* The minimum time to wait on each channel for active scans + * when it's possible to have longer scan dwell times. + * Currently this is used whenever we're idle on all interfaces. + * Longer dwell times improve detection of networks within a + * single scan. * * Range: u32 tu/1000 */ - u32 min_dwell_time_passive; + u32 min_dwell_time_active_long; - /* - * The maximum time to wait on each channel for passive scans + /* The maximum time to wait on each channel for active scans + * when it's possible to have longer scan dwell times. + * See min_dwell_time_active_long * * Range: u32 tu/1000 */ - u32 max_dwell_time_passive; + u32 max_dwell_time_active_long; + + /* time to wait on the channel for passive scans (in TU/1000) */ + u32 dwell_time_passive; + + /* time to wait on the channel for DFS scans (in TU/1000) */ + u32 dwell_time_dfs; /* * Number of probe requests to transmit on each active scan channel @@ -1276,12 +1331,20 @@ struct conf_hangover_settings { u8 window_size; } __packed; +struct conf_recovery_settings { + /* BUG() on fw recovery */ + u8 bug_on_recovery; + + /* Prevent HW recovery. FW will remain stuck. */ + u8 no_recovery; +} __packed; + /* * The conf version consists of 4 bytes. The two MSB are the wlcore * version, the two LSB are the lower driver's private conf * version. */ -#define WLCORE_CONF_VERSION (0x0002 << 16) +#define WLCORE_CONF_VERSION (0x0005 << 16) #define WLCORE_CONF_MASK 0xffff0000 #define WLCORE_CONF_SIZE (sizeof(struct wlcore_conf_header) + \ sizeof(struct wlcore_conf)) @@ -1309,6 +1372,7 @@ struct wlcore_conf { struct conf_fwlog fwlog; struct conf_rate_policy_settings rate; struct conf_hangover_settings hangover; + struct conf_recovery_settings recovery; } __packed; struct wlcore_conf_file { |