1 files changed, 0 insertions, 45 deletions
diff --git a/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt b/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt
deleted file mode 100644
index 3122ded82eb4..000000000000
--- a/Documentation/devicetree/bindings/media/st,stm32-dcmi.txt
+++ /dev/null
@@ -1,45 +0,0 @@
-STMicroelectronics STM32 Digital Camera Memory Interface (DCMI)
-
-Required properties:
-- compatible: "st,stm32-dcmi"
-- reg: physical base address and length of the registers set for the device
-- interrupts: should contain IRQ line for the DCMI
-- resets: reference to a reset controller,
-          see Documentation/devicetree/bindings/reset/st,stm32-rcc.txt
-- clocks: list of clock specifiers, corresponding to entries in
-          the clock-names property
-- clock-names: must contain "mclk", which is the DCMI peripherial clock
-- pinctrl: the pincontrol settings to configure muxing properly
-           for pins that connect to DCMI device.
-           See Documentation/devicetree/bindings/pinctrl/st,stm32-pinctrl.yaml.
-- dmas: phandle to DMA controller node,
-        see Documentation/devicetree/bindings/dma/stm32-dma.txt
-- dma-names: must contain "tx", which is the transmit channel from DCMI to DMA
-
-DCMI supports a single port node with parallel bus. It should contain one
-'port' child node with child 'endpoint' node. Please refer to the bindings
-defined in Documentation/devicetree/bindings/media/video-interfaces.txt.
-
-Example:
-
-	dcmi: dcmi@50050000 {
-		compatible = "st,stm32-dcmi";
-		reg = <0x50050000 0x400>;
-		interrupts = <78>;
-		resets = <&rcc STM32F4_AHB2_RESET(DCMI)>;
-		clocks = <&rcc 0 STM32F4_AHB2_CLOCK(DCMI)>;
-		clock-names = "mclk";
-		pinctrl-names = "default";
-		pinctrl-0 = <&dcmi_pins>;
-		dmas = <&dma2 1 1 0x414 0x3>;
-		dma-names = "tx";
-		port {
-			dcmi_0: endpoint {
-				remote-endpoint = <...>;
-				bus-width = <8>;
-				hsync-active = <0>;
-				vsync-active = <0>;
-				pclk-sample = <1>;
-			};
-		};
-	};