dt-bindings: display: bridge: thc63lvd1024: Convert binding to YAML

Convert the Thine THC63LVD1024 text binding to YAML.

Signed-off-by: Laurent Pinchart <laurent.pinchart+renesas@ideasonboard.com>
Acked-by: Maxime Ripard <mripard@kernel.org>
Reviewed-by: Jacopo Mondi <jacopo+renesas@jmondi.org>
Reviewed-by: Rob Herring <robh@kernel.org>

1 files changed, 0 insertions, 66 deletions

diff --git a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt b/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
deleted file mode 100644
index d17d1e5820d7..000000000000
--- a/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
+++ /dev/null
@@ -1,66 +0,0 @@
-Thine Electronics THC63LVD1024 LVDS decoder
--------------------------------------------
-
-The THC63LVD1024 is a dual link LVDS receiver designed to convert LVDS streams
-to parallel data outputs. The chip supports single/dual input/output modes,
-handling up to two LVDS input streams and up to two digital CMOS/TTL outputs.
-
-Single or dual operation mode, output data mapping and DDR output modes are
-configured through input signals and the chip does not expose any control bus.
-
-Required properties:
-- compatible: Shall be "thine,thc63lvd1024"
-- vcc-supply: Power supply for TTL output, TTL CLOCKOUT signal, LVDS input,
-  PPL and digital circuitry
-
-Optional properties:
-- powerdown-gpios: Power down GPIO signal, pin name "/PDWN". Active low
-- oe-gpios: Output enable GPIO signal, pin name "OE". Active high
-
-The THC63LVD1024 video port connections are modeled according
-to OF graph bindings specified by Documentation/devicetree/bindings/graph.txt
-
-Required video port nodes:
-- port@0: First LVDS input port
-- port@2: First digital CMOS/TTL parallel output
-
-Optional video port nodes:
-- port@1: Second LVDS input port
-- port@3: Second digital CMOS/TTL parallel output
-
-The device can operate in single-link mode or dual-link mode. In single-link
-mode, all pixels are received on port@0, and port@1 shall not contain any
-endpoint. In dual-link mode, even-numbered pixels are received on port@0 and
-odd-numbered pixels on port@1, and both port@0 and port@1 shall contain
-endpoints.
-
-Example:
---------
-
-	thc63lvd1024: lvds-decoder {
-		compatible = "thine,thc63lvd1024";
-
-		vcc-supply = <&reg_lvds_vcc>;
-		powerdown-gpios = <&gpio4 15 GPIO_ACTIVE_LOW>;
-
-		ports {
-			#address-cells = <1>;
-			#size-cells = <0>;
-
-			port@0 {
-				reg = <0>;
-
-				lvds_dec_in_0: endpoint {
-					remote-endpoint = <&lvds_out>;
-				};
-			};
-
-			port@2{
-				reg = <2>;
-
-				lvds_dec_out_2: endpoint {
-					remote-endpoint = <&adv7511_in>;
-				};
-			};
-		};
-	};