Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1674 commits)
  qlcnic: adding co maintainer
  ixgbe: add support for active DA cables
  ixgbe: dcb, do not tag tc_prio_control frames
  ixgbe: fix ixgbe_tx_is_paused logic
  ixgbe: always enable vlan strip/insert when DCB is enabled
  ixgbe: remove some redundant code in setting FCoE FIP filter
  ixgbe: fix wrong offset to fc_frame_header in ixgbe_fcoe_ddp
  ixgbe: fix header len when unsplit packet overflows to data buffer
  ipv6: Never schedule DAD timer on dead address
  ipv6: Use POSTDAD state
  ipv6: Use state_lock to protect ifa state
  ipv6: Replace inet6_ifaddr->dead with state
  cxgb4: notify upper drivers if the device is already up when they load
  cxgb4: keep interrupts available when the ports are brought down
  cxgb4: fix initial addition of MAC address
  cnic: Return SPQ credit to bnx2x after ring setup and shutdown.
  cnic: Convert cnic_local_flags to atomic ops.
  can: Fix SJA1000 command register writes on SMP systems
  bridge: fix build for CONFIG_SYSFS disabled
  ARCNET: Limit com20020 PCI ID matches for SOHARD cards
  ...

Fix up various conflicts with pcmcia tree drivers/net/
{pcmcia/3c589_cs.c, wireless/orinoco/orinoco_cs.c and
wireless/orinoco/spectrum_cs.c} and feature removal
(Documentation/feature-removal-schedule.txt).

Also fix a non-content conflict due to pm_qos_requirement getting
renamed in the PM tree (now pm_qos_request) in net/mac80211/scan.c

1 files changed, 12 insertions, 0 deletions

diff --git a/net/sctp/Kconfig b/net/sctp/Kconfig
index 58b3e882a187..126b014eb79b 100644
--- a/net/sctp/Kconfig
+++ b/net/sctp/Kconfig
@@ -37,6 +37,18 @@ menuconfig IP_SCTP
 
 if IP_SCTP
 
+config NET_SCTPPROBE
+	tristate "SCTP: Association probing"
+        depends on PROC_FS && KPROBES
+        ---help---
+        This module allows for capturing the changes to SCTP association
+        state in response to incoming packets. It is used for debugging
+        SCTP congestion control algorithms. If you don't understand
+        what was just said, you don't need it: say N.
+
+        To compile this code as a module, choose M here: the
+        module will be called sctp_probe.
+
 config SCTP_DBG_MSG
 	bool "SCTP: Debug messages"
 	help