1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
|
'\" t
.\" This manpage is Copyright (C) 1996 Michael Haardt.
.\" Updates Nov 1998, Andries Brouwer
.\"
.\" %%%LICENSE_START(VERBATIM)
.\" Permission is granted to make and distribute verbatim copies of this
.\" manual provided the copyright notice and this permission notice are
.\" preserved on all copies.
.\"
.\" Permission is granted to copy and distribute modified versions of this
.\" manual under the conditions for verbatim copying, provided that the
.\" entire resulting derived work is distributed under the terms of a
.\" permission notice identical to this one.
.\"
.\" Since the Linux kernel and libraries are constantly changing, this
.\" manual page may be incorrect or out-of-date. The author(s) assume no
.\" responsibility for errors or omissions, or for damages resulting from
.\" the use of the information contained herein. The author(s) may not
.\" have taken the same level of care in the production of this manual,
.\" which is licensed free of charge, as they might when working
.\" professionally.
.\"
.\" Formatted or processed versions of this manual, if unaccompanied by
.\" the source, must acknowledge the copyright and authors of this work.
.\" %%%LICENSE_END
.TH MOUSE 4 1996-02-10 "Linux" "Linux Programmer's Manual"
.SH NAME
mouse \- serial mouse interface
.SH CONFIGURATION
Serial mice are connected to a serial RS232/V24 dialout line, see
.BR ttyS (4)
for a description.
.SH DESCRIPTION
.SS Introduction
The pinout of the usual 9 pin plug as used for serial mice is:
.TS
center;
r c l.
pin name used for
2 RX Data
3 TX \-12 V, Imax = 10 mA
4 DTR +12 V, Imax = 10 mA
7 RTS +12 V, Imax = 10 mA
5 GND Ground
.TE
This is the specification, in fact 9 V suffices with most mice.
.PP
The mouse driver can recognize a mouse by dropping RTS to low and raising
it again.
About 14 ms later the mouse will send 0x4D (\(aqM\(aq) on the data line.
After a further 63 ms, a Microsoft-compatible 3-button mouse will send
0x33 (\(aq3\(aq).
.PP
The relative mouse movement is sent as
.I dx
(positive means right)
and
.I dy
(positive means down).
Various mice can operate at different speeds.
To select speeds, cycle through the
speeds 9600, 4800, 2400 and 1200 bit/s, each time writing the two characters
from the table below and waiting 0.1 seconds.
The following table shows available speeds and the strings that select them:
.TS
center;
l l.
bit/s string
9600 *q
4800 *p
2400 *o
1200 *n
.TE
The first byte of a data packet can be used to synchronization purposes.
.SS Microsoft protocol
The
.B Microsoft
protocol uses 1 start bit, 7 data bits, no parity
and one stop bit at the speed of 1200 bits/sec.
Data is sent to RxD in 3-byte packets.
The
.IR dx
and
.I dy
movements are sent as
two's-complement,
.I lb
.RI ( rb )
are set when the left (right)
button is pressed:
.TS
center;
r c c c c c c c.
byte d6 d5 d4 d3 d2 d1 d0
1 1 lb rb dy7 dy6 dx7 dx6
2 0 dx5 dx4 dx3 dx2 dx1 dx0
3 0 dy5 dy4 dy3 dy2 dy1 dy0
.TE
.SS 3-button Microsoft protocol
Original Microsoft mice only have two buttons.
However, there are some
three button mice which also use the Microsoft protocol.
Pressing or
releasing the middle button is reported by sending a packet with zero
movement and no buttons pressed.
(Thus, unlike for the other two buttons, the status of the middle
button is not reported in each packet.)
.SS Logitech protocol
Logitech serial 3-button mice use a different extension of the
Microsoft protocol: when the middle button is up, the above 3-byte
packet is sent.
When the middle button is down a 4-byte packet is
sent, where the 4th byte has value 0x20 (or at least has the 0x20
bit set).
In particular, a press of the middle button is reported
as 0,0,0,0x20 when no other buttons are down.
.SS Mousesystems protocol
The
.B Mousesystems
protocol uses 1 start bit, 8 data bits, no parity
and two stop bits at the speed of 1200 bits/sec.
Data is sent to RxD in
5-byte packets.
.I dx
is sent as the sum of the two two's-complement
values,
.I dy
is send as negated sum of the two two's-complement
values.
.I lb
.RI ( mb ,
.IR rb )
are cleared when the left (middle,
right) button is pressed:
.TS
center;
r c c c c c c c c.
byte d7 d6 d5 d4 d3 d2 d1 d0
1 1 0 0 0 0 lb mb rb
2 0 dxa6 dxa5 dxa4 dxa3 dxa2 dxa1 dxa0
3 0 dya6 dya5 dya4 dya3 dya2 dya1 dya0
4 0 dxb6 dxb5 dxb4 dxb3 dxb2 dxb1 dxb0
5 0 dyb6 dyb5 dyb4 dyb3 dyb2 dyb1 dyb0
.TE
Bytes 4 and 5 describe the change that occurred since bytes 2 and 3
were transmitted.
.SS Sun protocol
The
.B Sun
protocol is the 3-byte version of the above 5-byte
Mousesystems protocol: the last two bytes are not sent.
.SS MM protocol
The
.B MM
protocol uses 1 start bit, 8 data bits, odd parity and one
stop bit at the speed of 1200 bits/sec.
Data is sent to RxD in 3-byte
packets.
.I dx
and
.I dy
are sent as single signed values, the
sign bit indicating a negative value.
.I lb
.RI ( mb ,
.IR rb )
are
set when the left (middle, right) button is pressed:
.TS
center;
r c c c c c c c c.
byte d7 d6 d5 d4 d3 d2 d1 d0
1 1 0 0 dxs dys lb mb rb
2 0 dx6 dx5 dx4 dx3 dx2 dx1 dx0
3 0 dy6 dy5 dy4 dy3 dy2 dy1 dy0
.TE
.SH FILES
.TP
.I /dev/mouse
A commonly used symlink pointing to a mouse device.
.SH SEE ALSO
.BR ttyS (4),
.BR gpm (8)
|
