Merge branch 'linus' into x86/boot, to pick up fixes

Signed-off-by: Ingo Molnar <mingo@kernel.org>

8 files changed, 41 insertions, 16 deletions

diff --git a/Documentation/devicetree/bindings/i2c/i2c.txt b/Documentation/devicetree/bindings/i2c/i2c.txt
index 5fa691e6f638..cee9d5055fa2 100644
--- a/Documentation/devicetree/bindings/i2c/i2c.txt
+++ b/Documentation/devicetree/bindings/i2c/i2c.txt
@@ -62,6 +62,9 @@ wants to support one of the below features, it should adapt the bindings below.
 	"irq" and "wakeup" names are recognized by I2C core, other names are
 	left to individual drivers.
 
+- host-notify
+	device uses SMBus host notify protocol instead of interrupt line.
+
 - multi-master
 	states that there is another master active on this bus. The OS can use
 	this information to adapt power management to keep the arbitration awake
@@ -81,6 +84,11 @@ Binding may contain optional "interrupts" property, describing interrupts
 used by the device. I2C core will assign "irq" interrupt (or the very first
 interrupt if not using interrupt names) as primary interrupt for the slave.
 
+Alternatively, devices supporting SMbus Host Notify, and connected to
+adapters that support this feature, may use "host-notify" property. I2C
+core will create a virtual interrupt for Host Notify and assign it as
+primary interrupt for the slave.
+
 Also, if device is marked as a wakeup source, I2C core will set up "wakeup"
 interrupt for the device. If "wakeup" interrupt name is not present in the
 binding, then primary interrupt will be used as wakeup interrupt.
diff --git a/Documentation/devicetree/bindings/input/tps65218-pwrbutton.txt b/Documentation/devicetree/bindings/input/tps65218-pwrbutton.txt
index 3e5b9793341f..8682ab6d4a50 100644
--- a/Documentation/devicetree/bindings/input/tps65218-pwrbutton.txt
+++ b/Documentation/devicetree/bindings/input/tps65218-pwrbutton.txt
@@ -8,8 +8,9 @@ This driver provides a simple power button event via an Interrupt.
 Required properties:
 - compatible: should be "ti,tps65217-pwrbutton" or "ti,tps65218-pwrbutton"
 
-Required properties for TPS65218:
+Required properties:
 - interrupts: should be one of the following
+   - <2>: For controllers compatible with tps65217
    - <3 IRQ_TYPE_EDGE_BOTH>: For controllers compatible with tps65218
 
 Examples:
@@ -17,6 +18,7 @@ Examples:
 &tps {
 	tps65217-pwrbutton {
 		compatible = "ti,tps65217-pwrbutton";
+		interrupts = <2>;
 	};
 };
 
diff --git a/Documentation/devicetree/bindings/mtd/tango-nand.txt b/Documentation/devicetree/bindings/mtd/tango-nand.txt
index ad5a02f2ac8c..cd1bf2ac9055 100644
--- a/Documentation/devicetree/bindings/mtd/tango-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/tango-nand.txt
@@ -5,7 +5,7 @@ Required properties:
 - compatible: "sigma,smp8758-nand"
 - reg: address/size of nfc_reg, nfc_mem, and pbus_reg
 - dmas: reference to the DMA channel used by the controller
-- dma-names: "nfc_sbox"
+- dma-names: "rxtx"
 - clocks: reference to the system clock
 - #address-cells: <1>
 - #size-cells: <0>
@@ -17,9 +17,9 @@ Example:
 
 	nandc: nand-controller@2c000 {
 		compatible = "sigma,smp8758-nand";
-		reg = <0x2c000 0x30 0x2d000 0x800 0x20000 0x1000>;
+		reg = <0x2c000 0x30>, <0x2d000 0x800>, <0x20000 0x1000>;
 		dmas = <&dma0 3>;
-		dma-names = "nfc_sbox";
+		dma-names = "rxtx";
 		clocks = <&clkgen SYS_CLK>;
 		#address-cells = <1>;
 		#size-cells = <0>;
diff --git a/Documentation/devicetree/bindings/net/mediatek-net.txt b/Documentation/devicetree/bindings/net/mediatek-net.txt
index c010fafc66a8..c7194e87d5f4 100644
--- a/Documentation/devicetree/bindings/net/mediatek-net.txt
+++ b/Documentation/devicetree/bindings/net/mediatek-net.txt
@@ -7,7 +7,7 @@ have dual GMAC each represented by a child node..
 * Ethernet controller node
 
 Required properties:
-- compatible: Should be "mediatek,mt7623-eth"
+- compatible: Should be "mediatek,mt2701-eth"
 - reg: Address and length of the register set for the device
 - interrupts: Should contain the three frame engines interrupts in numeric
 	order. These are fe_int0, fe_int1 and fe_int2.
diff --git a/Documentation/devicetree/bindings/net/phy.txt b/Documentation/devicetree/bindings/net/phy.txt
index ff1bc4b1bb3b..fb5056b22685 100644
--- a/Documentation/devicetree/bindings/net/phy.txt
+++ b/Documentation/devicetree/bindings/net/phy.txt
@@ -19,8 +19,9 @@ Optional Properties:
   specifications. If neither of these are specified, the default is to
   assume clause 22.
 
-  If the phy's identifier is known then the list may contain an entry
-  of the form: "ethernet-phy-idAAAA.BBBB" where
+  If the PHY reports an incorrect ID (or none at all) then the
+  "compatible" list may contain an entry with the correct PHY ID in the
+  form: "ethernet-phy-idAAAA.BBBB" where
      AAAA - The value of the 16 bit Phy Identifier 1 register as
             4 hex digits. This is the chip vendor OUI bits 3:18
      BBBB - The value of the 16 bit Phy Identifier 2 register as
diff --git a/Documentation/devicetree/bindings/net/ti,dp83867.txt b/Documentation/devicetree/bindings/net/ti,dp83867.txt
index 85bf945b898f..afe9630a5e7d 100644
--- a/Documentation/devicetree/bindings/net/ti,dp83867.txt
+++ b/Documentation/devicetree/bindings/net/ti,dp83867.txt
@@ -3,9 +3,11 @@
 Required properties:
 	- reg - The ID number for the phy, usually a small integer
 	- ti,rx-internal-delay - RGMII Receive Clock Delay - see dt-bindings/net/ti-dp83867.h
-		for applicable values
+		for applicable values. Required only if interface type is
+		PHY_INTERFACE_MODE_RGMII_ID or PHY_INTERFACE_MODE_RGMII_RXID
 	- ti,tx-internal-delay - RGMII Transmit Clock Delay - see dt-bindings/net/ti-dp83867.h
-		for applicable values
+		for applicable values. Required only if interface type is
+		PHY_INTERFACE_MODE_RGMII_ID or PHY_INTERFACE_MODE_RGMII_TXID
 	- ti,fifo-depth - Transmitt FIFO depth- see dt-bindings/net/ti-dp83867.h
 		for applicable values
 
diff --git a/Documentation/devicetree/bindings/power/supply/tps65217_charger.txt b/Documentation/devicetree/bindings/power/supply/tps65217_charger.txt
index 98d131acee95..a11072c5a866 100644
--- a/Documentation/devicetree/bindings/power/supply/tps65217_charger.txt
+++ b/Documentation/devicetree/bindings/power/supply/tps65217_charger.txt
@@ -2,11 +2,16 @@ TPS65217 Charger
 
 Required Properties:
 -compatible: "ti,tps65217-charger"
+-interrupts: TPS65217 interrupt numbers for the AC and USB charger input change.
+             Should be <0> for the USB charger and <1> for the AC adapter.
+-interrupt-names: Should be "USB" and "AC"
 
 This node is a subnode of the tps65217 PMIC.
 
 Example:
 
 	tps65217-charger {
-		compatible = "ti,tps65090-charger";
+		compatible = "ti,tps65217-charger";
+		interrupts = <0>, <1>;
+		interrupt-names = "USB", "AC";
 	};
diff --git a/Documentation/devicetree/bindings/spi/sh-msiof.txt b/Documentation/devicetree/bindings/spi/sh-msiof.txt
index da6614c63796..dc975064fa27 100644
--- a/Documentation/devicetree/bindings/spi/sh-msiof.txt
+++ b/Documentation/devicetree/bindings/spi/sh-msiof.txt
@@ -1,17 +1,23 @@
 Renesas MSIOF spi controller
 
 Required properties:
-- compatible           : "renesas,msiof-<soctype>" for SoCs,
-			 "renesas,sh-msiof" for SuperH, or
-			 "renesas,sh-mobile-msiof" for SH Mobile series.
-			 Examples with soctypes are:
-			 "renesas,msiof-r8a7790" (R-Car H2)
+- compatible           : "renesas,msiof-r8a7790" (R-Car H2)
 			 "renesas,msiof-r8a7791" (R-Car M2-W)
 			 "renesas,msiof-r8a7792" (R-Car V2H)
 			 "renesas,msiof-r8a7793" (R-Car M2-N)
 			 "renesas,msiof-r8a7794" (R-Car E2)
 			 "renesas,msiof-r8a7796" (R-Car M3-W)
 			 "renesas,msiof-sh73a0" (SH-Mobile AG5)
+			 "renesas,sh-mobile-msiof" (generic SH-Mobile compatibile device)
+			 "renesas,rcar-gen2-msiof" (generic R-Car Gen2 compatible device)
+			 "renesas,rcar-gen3-msiof" (generic R-Car Gen3 compatible device)
+			 "renesas,sh-msiof"      (deprecated)
+
+			 When compatible with the generic version, nodes
+			 must list the SoC-specific version corresponding
+			 to the platform first followed by the generic
+			 version.
+
 - reg                  : A list of offsets and lengths of the register sets for
 			 the device.
 			 If only one register set is present, it is to be used
@@ -61,7 +67,8 @@ Documentation/devicetree/bindings/pinctrl/renesas,*.
 Example:
 
 	msiof0: spi@e6e20000 {
-		compatible = "renesas,msiof-r8a7791";
+		compatible = "renesas,msiof-r8a7791",
+			     "renesas,rcar-gen2-msiof";
 		reg = <0 0xe6e20000 0 0x0064>;
 		interrupts = <0 156 IRQ_TYPE_LEVEL_HIGH>;
 		clocks = <&mstp0_clks R8A7791_CLK_MSIOF0>;