summaryrefslogtreecommitdiff
path: root/arch/powerpc/boot/dts/gef_sbc610.dts
AgeCommit message (Expand)AuthorFilesLines
2014-01-16dt/bindings: Remove all references to device_type "ethernet-phy"Grant Likely1-2/+0
2012-01-04powerpc/fsl: update compatiable on fsl 16550 uart nodesKumar Gala1-2/+2
2011-11-03powerpc/86xx: Correct Gianfar support for GE boardsMartyn Welch1-4/+29
2010-03-04powerpc/86xx: Renaming following split of GE Fanuc joint ventureMartyn Welch1-2/+2
2010-02-17powerpc/86xx: Basic flash support for GE SBC610Martyn Welch1-8/+42
2010-02-17powerpc/86xx: Add MSI section to GE SBC610 DTSMalcolm Crossley1-0/+16
2009-11-20powerpc/86xx: Enable NVRAM on GE Fanuc's SBC610Martyn Welch1-0/+6
2009-06-15powerpc/86xx: Add I2C device mappings in DTS for SBC610Martyn Welch1-0/+10
2009-05-19powerpc/fsl: Removed reg property from 85xx/86xx soc nodeKumar Gala1-1/+0
2009-05-19powerpc/86xx: Add new LAW & MCM device tree nodes for all 86xx systemsKumar Gala1-0/+13
2009-03-24powerpc/86xx: Move gianfar mdio nodes under the ethernet nodesAnton Vorontsov1-18/+21
2009-03-09powerpc/86xx: Correct local bus registers in GE Fanuc SBC610 dts fileMartyn Welch1-1/+1
2009-01-12[WATCHDOG] Enable watchdog timer on GE Fanuc's SBC610Martyn Welch1-0/+15
2008-12-03powerpc/86xx: Basic GPIO support for GE Fanuc SBC610Martyn Welch1-0/+6
2008-12-03powerpc/86xx: Add use of Epson RTX-8581 RTC to GE Fanuc SBC610 dtsMartyn Welch1-0/+5
2008-11-08powerpc/86xx: Correct SOC bus-frequency in GE Fanuc SBC610 DTSMartyn Welch1-1/+1
2008-10-13powerpc: FPGA support for GE Fanuc SBC610Martyn Welch1-0/+4
2008-10-13powerpc: GE Fanuc's FPGA based PIC controller on the SBC610Martyn Welch1-4/+33
2008-09-16powerpc: Board support for GE Fanuc SBC610Martyn Welch1-0/+260
generated by cgit v1.2.3 (git 2.39.1) at 2024-12-23 18:58:45 +0000