Merge branch 'x86-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip

Pull x86 fixes from Thomas Gleixner:
 "Hopefully the last round of fixes for 3.19

   - regression fix for the LDT changes
   - regression fix for XEN interrupt handling caused by the APIC
     changes
   - regression fixes for the PAT changes
   - last minute fixes for new the MPX support
   - regression fix for 32bit UP
   - fix for a long standing relocation issue on 64bit tagged for stable
   - functional fix for the Hyper-V clocksource tagged for stable
   - downgrade of a pr_err which tends to confuse users

  Looks a bit on the large side, but almost half of it are valuable
  comments"

* 'x86-urgent-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  x86/tsc: Change Fast TSC calibration failed from error to info
  x86/apic: Re-enable PCI_MSI support for non-SMP X86_32
  x86, mm: Change cachemode exports to non-gpl
  x86, tls: Interpret an all-zero struct user_desc as "no segment"
  x86, tls, ldt: Stop checking lm in LDT_empty
  x86, mpx: Strictly enforce empty prctl() args
  x86, mpx: Fix potential performance issue on unmaps
  x86, mpx: Explicitly disable 32-bit MPX support on 64-bit kernels
  x86, hyperv: Mark the Hyper-V clocksource as being continuous
  x86: Don't rely on VMWare emulating PAT MSR correctly
  x86, irq: Properly tag virtualization entry in /proc/interrupts
  x86, boot: Skip relocs when load address unchanged
  x86/xen: Override ACPI IRQ management callback __acpi_unregister_gsi
  ACPI: pci: Do not clear pci_dev->irq in acpi_pci_irq_disable()
  x86/xen: Treat SCI interrupt as normal GSI interrupt

1 files changed, 2 insertions, 47 deletions

diff --git a/arch/x86/pci/xen.c b/arch/x86/pci/xen.c
index c489ef2c1a39..9098d880c476 100644
--- a/arch/x86/pci/xen.c
+++ b/arch/x86/pci/xen.c
@@ -458,6 +458,7 @@ int __init pci_xen_hvm_init(void)
 	 * just how GSIs get registered.
 	 */
 	__acpi_register_gsi = acpi_register_gsi_xen_hvm;
+	__acpi_unregister_gsi = NULL;
 #endif
 
 #ifdef CONFIG_PCI_MSI
@@ -471,52 +472,6 @@ int __init pci_xen_hvm_init(void)
 }
 
 #ifdef CONFIG_XEN_DOM0
-static __init void xen_setup_acpi_sci(void)
-{
-	int rc;
-	int trigger, polarity;
-	int gsi = acpi_sci_override_gsi;
-	int irq = -1;
-	int gsi_override = -1;
-
-	if (!gsi)
-		return;
-
-	rc = acpi_get_override_irq(gsi, &trigger, &polarity);
-	if (rc) {
-		printk(KERN_WARNING "xen: acpi_get_override_irq failed for acpi"
-				" sci, rc=%d\n", rc);
-		return;
-	}
-	trigger = trigger ? ACPI_LEVEL_SENSITIVE : ACPI_EDGE_SENSITIVE;
-	polarity = polarity ? ACPI_ACTIVE_LOW : ACPI_ACTIVE_HIGH;
-
-	printk(KERN_INFO "xen: sci override: global_irq=%d trigger=%d "
-			"polarity=%d\n", gsi, trigger, polarity);
-
-	/* Before we bind the GSI to a Linux IRQ, check whether
-	 * we need to override it with bus_irq (IRQ) value. Usually for
-	 * IRQs below IRQ_LEGACY_IRQ this holds IRQ == GSI, as so:
-	 *  ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 9 low level)
-	 * but there are oddballs where the IRQ != GSI:
-	 *  ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 20 low level)
-	 * which ends up being: gsi_to_irq[9] == 20
-	 * (which is what acpi_gsi_to_irq ends up calling when starting the
-	 * the ACPI interpreter and keels over since IRQ 9 has not been
-	 * setup as we had setup IRQ 20 for it).
-	 */
-	if (acpi_gsi_to_irq(gsi, &irq) == 0) {
-		/* Use the provided value if it's valid. */
-		if (irq >= 0)
-			gsi_override = irq;
-	}
-
-	gsi = xen_register_gsi(gsi, gsi_override, trigger, polarity);
-	printk(KERN_INFO "xen: acpi sci %d\n", gsi);
-
-	return;
-}
-
 int __init pci_xen_initial_domain(void)
 {
 	int irq;
@@ -527,8 +482,8 @@ int __init pci_xen_initial_domain(void)
 	x86_msi.restore_msi_irqs = xen_initdom_restore_msi_irqs;
 	pci_msi_ignore_mask = 1;
 #endif
-	xen_setup_acpi_sci();
 	__acpi_register_gsi = acpi_register_gsi_xen;
+	__acpi_unregister_gsi = NULL;
 	/* Pre-allocate legacy irqs */
 	for (irq = 0; irq < nr_legacy_irqs(); irq++) {
 		int trigger, polarity;