diff options
author | Linus Torvalds <torvalds@linux-foundation.org> | 2019-09-16 15:52:38 -0700 |
---|---|---|
committer | Linus Torvalds <torvalds@linux-foundation.org> | 2019-09-16 15:52:38 -0700 |
commit | 399eb9b6cbf31ff6ef91a6930e2e94c703d74078 (patch) | |
tree | 60c26e51c167efdfec5ab5821111df9ea90cbf7f /drivers/gpio | |
parent | 2b97c39514a6130f38b14227a36d9cd37e650a9d (diff) | |
parent | 3dc8dcb02fdba3370aec0696727e6adfe8033aa4 (diff) |
Merge tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc
Pull ARM SoC driver updates from Arnd Bergmann:
"This contains driver changes that are tightly connected to SoC
specific code. Aside from smaller cleanups and bug fixes, here is a
list of the notable changes.
New device drivers:
- The Turris Mox router has a new "moxtet" bus driver for its
on-board pluggable extension bus. The same platform also gains a
firmware driver.
- The Samsung Exynos family gains a new Chipid driver exporting using
the soc device sysfs interface
- A similar socinfo driver for Qualcomm Snapdragon chips.
- A firmware driver for the NXP i.MX DSP IPC protocol using shared
memory and a mailbox
Other changes:
- The i.MX reset controller driver now supports the NXP i.MX8MM chip
- Amlogic SoC specific drivers gain support for the S905X3 and A311D
chips
- A rework of the TI Davinci framebuffer driver to allow important
cleanups in the platform code
- A couple of device drivers for removed ARM SoC platforms are
removed. Most of the removals were picked up by other maintainers,
this contains whatever was left"
* tag 'armsoc-drivers' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (123 commits)
bus: uniphier-system-bus: use devm_platform_ioremap_resource()
soc: ti: ti_sci_pm_domains: Add support for exclusive and shared access
dt-bindings: ti_sci_pm_domains: Add support for exclusive and shared access
firmware: ti_sci: Allow for device shared and exclusive requests
bus: imx-weim: remove incorrect __init annotations
fbdev: remove w90x900/nuc900 platform drivers
spi: remove w90x900 driver
net: remove w90p910-ether driver
net: remove ks8695 driver
firmware: turris-mox-rwtm: Add sysfs documentation
firmware: Add Turris Mox rWTM firmware driver
dt-bindings: firmware: Document cznic,turris-mox-rwtm binding
bus: moxtet: fix unsigned comparison to less than zero
bus: moxtet: remove set but not used variable 'dummy'
ARM: scoop: Use the right include
dt-bindings: power: add Amlogic Everything-Else power domains bindings
soc: amlogic: Add support for Everything-Else power domains controller
fbdev: da8xx: use resource management for dma
fbdev: da8xx-fb: drop a redundant if
fbdev: da8xx-fb: use devm_platform_ioremap_resource()
...
Diffstat (limited to 'drivers/gpio')
-rw-r--r-- | drivers/gpio/Kconfig | 9 | ||||
-rw-r--r-- | drivers/gpio/Makefile | 1 | ||||
-rw-r--r-- | drivers/gpio/gpio-moxtet.c | 179 |
3 files changed, 189 insertions, 0 deletions
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index 305b47ed4532..38e096e6925f 100644 --- a/drivers/gpio/Kconfig +++ b/drivers/gpio/Kconfig @@ -1453,6 +1453,15 @@ config GPIO_XRA1403 help GPIO driver for EXAR XRA1403 16-bit SPI-based GPIO expander. +config GPIO_MOXTET + tristate "Turris Mox Moxtet bus GPIO expander" + depends on MOXTET + help + Say yes here if you are building for the Turris Mox router. + This is the driver needed for configuring the GPIOs via the Moxtet + bus. For example the Mox module with SFP cage needs this driver + so that phylink can use corresponding GPIOs. + endmenu menu "USB GPIO expanders" diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index f3e051fb50e6..d2fd19c15bae 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -92,6 +92,7 @@ obj-$(CONFIG_GPIO_ML_IOH) += gpio-ml-ioh.o obj-$(CONFIG_GPIO_MLXBF) += gpio-mlxbf.o obj-$(CONFIG_GPIO_MM_LANTIQ) += gpio-mm-lantiq.o obj-$(CONFIG_GPIO_MOCKUP) += gpio-mockup.o +obj-$(CONFIG_GPIO_MOXTET) += gpio-moxtet.o obj-$(CONFIG_GPIO_MPC5200) += gpio-mpc5200.o obj-$(CONFIG_GPIO_MPC8XXX) += gpio-mpc8xxx.o obj-$(CONFIG_GPIO_MSIC) += gpio-msic.o diff --git a/drivers/gpio/gpio-moxtet.c b/drivers/gpio/gpio-moxtet.c new file mode 100644 index 000000000000..3fd729994a38 --- /dev/null +++ b/drivers/gpio/gpio-moxtet.c @@ -0,0 +1,179 @@ +// SPDX-License-Identifier: GPL-2.0 +/* + * Turris Mox Moxtet GPIO expander + * + * Copyright (C) 2018 Marek Behun <marek.behun@nic.cz> + */ + +#include <linux/bitops.h> +#include <linux/gpio/driver.h> +#include <linux/moxtet.h> +#include <linux/module.h> + +#define MOXTET_GPIO_NGPIOS 12 +#define MOXTET_GPIO_INPUTS 4 + +struct moxtet_gpio_desc { + u16 in_mask; + u16 out_mask; +}; + +static const struct moxtet_gpio_desc descs[] = { + [TURRIS_MOX_MODULE_SFP] = { + .in_mask = GENMASK(2, 0), + .out_mask = GENMASK(5, 4), + }, +}; + +struct moxtet_gpio_chip { + struct device *dev; + struct gpio_chip gpio_chip; + const struct moxtet_gpio_desc *desc; +}; + +static int moxtet_gpio_get_value(struct gpio_chip *gc, unsigned int offset) +{ + struct moxtet_gpio_chip *chip = gpiochip_get_data(gc); + int ret; + + if (chip->desc->in_mask & BIT(offset)) { + ret = moxtet_device_read(chip->dev); + } else if (chip->desc->out_mask & BIT(offset)) { + ret = moxtet_device_written(chip->dev); + if (ret >= 0) + ret <<= MOXTET_GPIO_INPUTS; + } else { + return -EINVAL; + } + + if (ret < 0) + return ret; + + return !!(ret & BIT(offset)); +} + +static void moxtet_gpio_set_value(struct gpio_chip *gc, unsigned int offset, + int val) +{ + struct moxtet_gpio_chip *chip = gpiochip_get_data(gc); + int state; + + state = moxtet_device_written(chip->dev); + if (state < 0) + return; + + offset -= MOXTET_GPIO_INPUTS; + + if (val) + state |= BIT(offset); + else + state &= ~BIT(offset); + + moxtet_device_write(chip->dev, state); +} + +static int moxtet_gpio_get_direction(struct gpio_chip *gc, unsigned int offset) +{ + struct moxtet_gpio_chip *chip = gpiochip_get_data(gc); + + /* All lines are hard wired to be either input or output, not both. */ + if (chip->desc->in_mask & BIT(offset)) + return 1; + else if (chip->desc->out_mask & BIT(offset)) + return 0; + else + return -EINVAL; +} + +static int moxtet_gpio_direction_input(struct gpio_chip *gc, + unsigned int offset) +{ + struct moxtet_gpio_chip *chip = gpiochip_get_data(gc); + + if (chip->desc->in_mask & BIT(offset)) + return 0; + else if (chip->desc->out_mask & BIT(offset)) + return -ENOTSUPP; + else + return -EINVAL; +} + +static int moxtet_gpio_direction_output(struct gpio_chip *gc, + unsigned int offset, int val) +{ + struct moxtet_gpio_chip *chip = gpiochip_get_data(gc); + + if (chip->desc->out_mask & BIT(offset)) + moxtet_gpio_set_value(gc, offset, val); + else if (chip->desc->in_mask & BIT(offset)) + return -ENOTSUPP; + else + return -EINVAL; + + return 0; +} + +static int moxtet_gpio_probe(struct device *dev) +{ + struct moxtet_gpio_chip *chip; + struct device_node *nc = dev->of_node; + int id; + + id = to_moxtet_device(dev)->id; + + if (id >= ARRAY_SIZE(descs)) { + dev_err(dev, "%pOF Moxtet device id 0x%x is not supported by gpio-moxtet driver\n", + nc, id); + return -ENOTSUPP; + } + + chip = devm_kzalloc(dev, sizeof(*chip), GFP_KERNEL); + if (!chip) + return -ENOMEM; + + chip->dev = dev; + chip->gpio_chip.parent = dev; + chip->desc = &descs[id]; + + dev_set_drvdata(dev, chip); + + chip->gpio_chip.label = dev_name(dev); + chip->gpio_chip.get_direction = moxtet_gpio_get_direction; + chip->gpio_chip.direction_input = moxtet_gpio_direction_input; + chip->gpio_chip.direction_output = moxtet_gpio_direction_output; + chip->gpio_chip.get = moxtet_gpio_get_value; + chip->gpio_chip.set = moxtet_gpio_set_value; + chip->gpio_chip.base = -1; + + chip->gpio_chip.ngpio = MOXTET_GPIO_NGPIOS; + + chip->gpio_chip.can_sleep = true; + chip->gpio_chip.owner = THIS_MODULE; + + return devm_gpiochip_add_data(dev, &chip->gpio_chip, chip); +} + +static const struct of_device_id moxtet_gpio_dt_ids[] = { + { .compatible = "cznic,moxtet-gpio", }, + {}, +}; +MODULE_DEVICE_TABLE(of, moxtet_gpio_dt_ids); + +static const enum turris_mox_module_id moxtet_gpio_module_table[] = { + TURRIS_MOX_MODULE_SFP, + 0, +}; + +static struct moxtet_driver moxtet_gpio_driver = { + .driver = { + .name = "moxtet-gpio", + .of_match_table = moxtet_gpio_dt_ids, + .probe = moxtet_gpio_probe, + }, + .id_table = moxtet_gpio_module_table, +}; +module_moxtet_driver(moxtet_gpio_driver); + +MODULE_AUTHOR("Marek Behun <marek.behun@nic.cz>"); +MODULE_DESCRIPTION("Turris Mox Moxtet GPIO expander"); +MODULE_LICENSE("GPL v2"); |