1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
|
// SPDX-License-Identifier: GPL-2.0-only
/*
* Copyright (C) 2015 - ARM Ltd
* Author: Marc Zyngier <marc.zyngier@arm.com>
*/
#include <asm/kvm_hyp.h>
#include <asm/kvm_mmu.h>
#include <asm/tlbflush.h>
struct tlb_inv_context {
u64 tcr;
};
static void __tlb_switch_to_guest(struct kvm_s2_mmu *mmu,
struct tlb_inv_context *cxt)
{
if (cpus_have_final_cap(ARM64_WORKAROUND_SPECULATIVE_AT)) {
u64 val;
/*
* For CPUs that are affected by ARM 1319367, we need to
* avoid a host Stage-1 walk while we have the guest's
* VMID set in the VTTBR in order to invalidate TLBs.
* We're guaranteed that the S1 MMU is enabled, so we can
* simply set the EPD bits to avoid any further TLB fill.
*/
val = cxt->tcr = read_sysreg_el1(SYS_TCR);
val |= TCR_EPD1_MASK | TCR_EPD0_MASK;
write_sysreg_el1(val, SYS_TCR);
isb();
}
/*
* __load_guest_stage2() includes an ISB only when the AT
* workaround is applied. Take care of the opposite condition,
* ensuring that we always have an ISB, but not two ISBs back
* to back.
*/
__load_guest_stage2(mmu);
asm(ALTERNATIVE("isb", "nop", ARM64_WORKAROUND_SPECULATIVE_AT));
}
static void __tlb_switch_to_host(struct tlb_inv_context *cxt)
{
write_sysreg(0, vttbr_el2);
if (cpus_have_final_cap(ARM64_WORKAROUND_SPECULATIVE_AT)) {
/* Ensure write of the host VMID */
isb();
/* Restore the host's TCR_EL1 */
write_sysreg_el1(cxt->tcr, SYS_TCR);
}
}
void __kvm_tlb_flush_vmid_ipa(struct kvm_s2_mmu *mmu,
phys_addr_t ipa, int level)
{
struct tlb_inv_context cxt;
dsb(ishst);
/* Switch to requested VMID */
__tlb_switch_to_guest(mmu, &cxt);
/*
* We could do so much better if we had the VA as well.
* Instead, we invalidate Stage-2 for this IPA, and the
* whole of Stage-1. Weep...
*/
ipa >>= 12;
__tlbi_level(ipas2e1is, ipa, level);
/*
* We have to ensure completion of the invalidation at Stage-2,
* since a table walk on another CPU could refill a TLB with a
* complete (S1 + S2) walk based on the old Stage-2 mapping if
* the Stage-1 invalidation happened first.
*/
dsb(ish);
__tlbi(vmalle1is);
dsb(ish);
isb();
/*
* If the host is running at EL1 and we have a VPIPT I-cache,
* then we must perform I-cache maintenance at EL2 in order for
* it to have an effect on the guest. Since the guest cannot hit
* I-cache lines allocated with a different VMID, we don't need
* to worry about junk out of guest reset (we nuke the I-cache on
* VMID rollover), but we do need to be careful when remapping
* executable pages for the same guest. This can happen when KSM
* takes a CoW fault on an executable page, copies the page into
* a page that was previously mapped in the guest and then needs
* to invalidate the guest view of the I-cache for that page
* from EL1. To solve this, we invalidate the entire I-cache when
* unmapping a page from a guest if we have a VPIPT I-cache but
* the host is running at EL1. As above, we could do better if
* we had the VA.
*
* The moral of this story is: if you have a VPIPT I-cache, then
* you should be running with VHE enabled.
*/
if (icache_is_vpipt())
__flush_icache_all();
__tlb_switch_to_host(&cxt);
}
void __kvm_tlb_flush_vmid(struct kvm_s2_mmu *mmu)
{
struct tlb_inv_context cxt;
dsb(ishst);
/* Switch to requested VMID */
__tlb_switch_to_guest(mmu, &cxt);
__tlbi(vmalls12e1is);
dsb(ish);
isb();
__tlb_switch_to_host(&cxt);
}
void __kvm_tlb_flush_local_vmid(struct kvm_s2_mmu *mmu)
{
struct tlb_inv_context cxt;
/* Switch to requested VMID */
mmu = kern_hyp_va(mmu);
__tlb_switch_to_guest(mmu, &cxt);
__tlbi(vmalle1);
dsb(nsh);
isb();
__tlb_switch_to_host(&cxt);
}
void __kvm_flush_vm_context(void)
{
dsb(ishst);
__tlbi(alle1is);
/*
* VIPT and PIPT caches are not affected by VMID, so no maintenance
* is necessary across a VMID rollover.
*
* VPIPT caches constrain lookup and maintenance to the active VMID,
* so we need to invalidate lines with a stale VMID to avoid an ABA
* race after multiple rollovers.
*
*/
if (icache_is_vpipt())
asm volatile("ic ialluis");
dsb(ish);
}
|
