diff options
Diffstat (limited to 'tools/testing/ktest/sample.conf')
| -rw-r--r-- | tools/testing/ktest/sample.conf | 42 |
1 files changed, 42 insertions, 0 deletions
diff --git a/tools/testing/ktest/sample.conf b/tools/testing/ktest/sample.conf index 3408c594b2de..4c5d6bd74a02 100644 --- a/tools/testing/ktest/sample.conf +++ b/tools/testing/ktest/sample.conf @@ -306,6 +306,14 @@ # (default 60) #STOP_AFTER_FAILURE = 60 +# In case the console constantly fills the screen, having +# a specified time to stop the test if it never succeeds nor fails +# is recommended. +# Note: this is ignored if a success or failure is detected. +# (in seconds) +# (default 600, -1 is to never stop) +#STOP_TEST_AFTER = 600 + # Stop testing if a build fails. If set, the script will end if # a failure is detected, otherwise it will save off the .config, # dmesg and bootlog in a directory called @@ -519,6 +527,24 @@ # git bisect good, git bisect bad, and running the git bisect replay # if the BISECT_REPLAY is set. # +# BISECT_SKIP = 1 (optional, default 0) +# +# If BISECT_TYPE is set to test but the build fails, ktest will +# simply fail the test and end their. You could use BISECT_REPLAY +# and BISECT_START to resume after you found a new starting point, +# or you could set BISECT_SKIP to 1. If BISECT_SKIP is set to 1, +# when something other than the BISECT_TYPE fails, ktest.pl will +# run "git bisect skip" and try again. +# +# BISECT_FILES = <path> (optional, default undefined) +# +# To just run the git bisect on a specific path, set BISECT_FILES. +# For example: +# +# BISECT_FILES = arch/x86 kernel/time +# +# Will run the bisect with "git bisect start -- arch/x86 kernel/time" +# # BISECT_REVERSE = 1 (optional, default 0) # # In those strange instances where it was broken forever @@ -528,6 +554,15 @@ # With BISECT_REVERSE = 1, The test will consider failures as # good, and success as bad. # +# BISECT_MANUAL = 1 (optional, default 0) +# +# In case there's a problem with automating the bisect for +# whatever reason. (Can't reboot, want to inspect each iteration) +# Doing a BISECT_MANUAL will have the test wait for you to +# tell it if the test passed or failed after each iteration. +# This is basicall the same as running git bisect yourself +# but ktest will rebuild and install the kernel for you. +# # BISECT_CHECK = 1 (optional, default 0) # # Just to be sure the good is good and bad is bad, setting @@ -613,10 +648,17 @@ # # CONFIG_BISECT is the config that failed to boot # +# If BISECT_MANUAL is set, it will pause between iterations. +# This is useful to use just ktest.pl just for the config bisect. +# If you set it to build, it will run the bisect and you can +# control what happens in between iterations. It will ask you if +# the test succeeded or not and continue the config bisect. +# # Example: # TEST_START # TEST_TYPE = config_bisect # CONFIG_BISECT_TYPE = build # CONFIG_BISECT = /home/test/˘onfig-bad # MIN_CONFIG = /home/test/config-min +# BISECT_MANUAL = 1 # |