4 files changed, 9 insertions, 22 deletions
diff --git a/drivers/net/wireless/ath/ath5k/ath5k.h b/drivers/net/wireless/ath/ath5k/ath5k.h
index 7ca0d6f930fd..e22b0e778927 100644
--- a/drivers/net/wireless/ath/ath5k/ath5k.h
+++ b/drivers/net/wireless/ath/ath5k/ath5k.h
@@ -1280,7 +1280,6 @@ struct ath5k_hw {
 
 	DECLARE_BITMAP(status, 4);
 #define ATH_STAT_INVALID	0		/* disable hardware accesses */
-#define ATH_STAT_PROMISC	1
 #define ATH_STAT_LEDSOFT	2		/* enable LED gpio status */
 #define ATH_STAT_STARTED	3		/* opened & irqs enabled */
 #define ATH_STAT_RESET		4		/* hw reset */
diff --git a/drivers/net/wireless/ath/ath5k/base.c b/drivers/net/wireless/ath/ath5k/base.c
index a6131825c9f6..23552f43d125 100644
--- a/drivers/net/wireless/ath/ath5k/base.c
+++ b/drivers/net/wireless/ath/ath5k/base.c
@@ -2537,12 +2537,12 @@ ath5k_init_ah(struct ath5k_hw *ah, const struct ath_bus_ops *bus_ops)
 
 	/* Initialize driver private data */
 	SET_IEEE80211_DEV(hw, ah->dev);
-	hw->flags = IEEE80211_HW_RX_INCLUDES_FCS |
-			IEEE80211_HW_HOST_BROADCAST_PS_BUFFERING |
-			IEEE80211_HW_SIGNAL_DBM |
-			IEEE80211_HW_MFP_CAPABLE |
-			IEEE80211_HW_REPORTS_TX_ACK_STATUS |
-			IEEE80211_HW_SUPPORTS_RC_TABLE;
+	ieee80211_hw_set(hw, SUPPORTS_RC_TABLE);
+	ieee80211_hw_set(hw, REPORTS_TX_ACK_STATUS);
+	ieee80211_hw_set(hw, MFP_CAPABLE);
+	ieee80211_hw_set(hw, SIGNAL_DBM);
+	ieee80211_hw_set(hw, RX_INCLUDES_FCS);
+	ieee80211_hw_set(hw, HOST_BROADCAST_PS_BUFFERING);
 
 	hw->wiphy->interface_modes =
 		BIT(NL80211_IFTYPE_AP) |
diff --git a/drivers/net/wireless/ath/ath5k/led.c b/drivers/net/wireless/ath/ath5k/led.c
index ca4b7ccd697f..803030fd17d3 100644
--- a/drivers/net/wireless/ath/ath5k/led.c
+++ b/drivers/net/wireless/ath/ath5k/led.c
@@ -124,7 +124,7 @@ ath5k_led_brightness_set(struct led_classdev *led_dev,
 
 static int
 ath5k_register_led(struct ath5k_hw *ah, struct ath5k_led *led,
-		   const char *name, char *trigger)
+		   const char *name, const char *trigger)
 {
 	int err;
 
diff --git a/drivers/net/wireless/ath/ath5k/mac80211-ops.c b/drivers/net/wireless/ath/ath5k/mac80211-ops.c
index 3b4a6463d87a..dc44cfef7517 100644
--- a/drivers/net/wireless/ath/ath5k/mac80211-ops.c
+++ b/drivers/net/wireless/ath/ath5k/mac80211-ops.c
@@ -369,7 +369,7 @@ ath5k_configure_filter(struct ieee80211_hw *hw, unsigned int changed_flags,
 		       unsigned int *new_flags, u64 multicast)
 {
 #define SUPPORTED_FIF_FLAGS \
-	(FIF_PROMISC_IN_BSS |  FIF_ALLMULTI | FIF_FCSFAIL | \
+	(FIF_ALLMULTI | FIF_FCSFAIL | \
 	FIF_PLCPFAIL | FIF_CONTROL | FIF_OTHER_BSS | \
 	FIF_BCN_PRBRESP_PROMISC)
 
@@ -393,16 +393,6 @@ ath5k_configure_filter(struct ieee80211_hw *hw, unsigned int changed_flags,
 		(AR5K_RX_FILTER_UCAST | AR5K_RX_FILTER_BCAST |
 		AR5K_RX_FILTER_MCAST);
 
-	if (changed_flags & (FIF_PROMISC_IN_BSS | FIF_OTHER_BSS)) {
-		if (*new_flags & FIF_PROMISC_IN_BSS)
-			__set_bit(ATH_STAT_PROMISC, ah->status);
-		else
-			__clear_bit(ATH_STAT_PROMISC, ah->status);
-	}
-
-	if (test_bit(ATH_STAT_PROMISC, ah->status))
-		rfilt |= AR5K_RX_FILTER_PROM;
-
 	/* Note, AR5K_RX_FILTER_MCAST is already enabled */
 	if (*new_flags & FIF_ALLMULTI) {
 		mfilt[0] =  ~0;
@@ -418,8 +408,7 @@ ath5k_configure_filter(struct ieee80211_hw *hw, unsigned int changed_flags,
 	if ((*new_flags & FIF_BCN_PRBRESP_PROMISC) || (ah->nvifs > 1))
 		rfilt |= AR5K_RX_FILTER_BEACON;
 
-	/* FIF_CONTROL doc says that if FIF_PROMISC_IN_BSS is not
-	 * set we should only pass on control frames for this
+	/* FIF_CONTROL doc says we should only pass on control frames for this
 	 * station. This needs testing. I believe right now this
 	 * enables *all* control frames, which is OK.. but
 	 * but we should see if we can improve on granularity */
@@ -809,7 +798,6 @@ const struct ieee80211_ops ath5k_hw_ops = {
 	.sw_scan_start		= ath5k_sw_scan_start,
 	.sw_scan_complete	= ath5k_sw_scan_complete,
 	.get_stats		= ath5k_get_stats,
-	/* .get_tkip_seq	= not implemented */
 	/* .set_frag_threshold	= not implemented */
 	/* .set_rts_threshold	= not implemented */
 	/* .sta_add		= not implemented */