diff options
Diffstat (limited to 'Documentation/spi')
| -rw-r--r-- | Documentation/spi/pxa2xx | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/Documentation/spi/pxa2xx b/Documentation/spi/pxa2xx index 13a0b7fb192f..551325b66b23 100644 --- a/Documentation/spi/pxa2xx +++ b/Documentation/spi/pxa2xx @@ -21,15 +21,15 @@ Typically a SPI master is defined in the arch/.../mach-*/board-*.c as a "platform device". The master configuration is passed to the driver via a table found in include/linux/spi/pxa2xx_spi.h: -struct pxa2xx_spi_master { +struct pxa2xx_spi_controller { u16 num_chipselect; u8 enable_dma; }; -The "pxa2xx_spi_master.num_chipselect" field is used to determine the number of +The "pxa2xx_spi_controller.num_chipselect" field is used to determine the number of slave device (chips) attached to this SPI master. -The "pxa2xx_spi_master.enable_dma" field informs the driver that SSP DMA should +The "pxa2xx_spi_controller.enable_dma" field informs the driver that SSP DMA should be used. This caused the driver to acquire two DMA channels: rx_channel and tx_channel. The rx_channel has a higher DMA service priority the tx_channel. See the "PXA2xx Developer Manual" section "DMA Controller". @@ -51,7 +51,7 @@ static struct resource pxa_spi_nssp_resources[] = { }, }; -static struct pxa2xx_spi_master pxa_nssp_master_info = { +static struct pxa2xx_spi_controller pxa_nssp_master_info = { .num_chipselect = 1, /* Matches the number of chips attached to NSSP */ .enable_dma = 1, /* Enables NSSP DMA */ }; @@ -206,7 +206,7 @@ DMA and PIO I/O Support ----------------------- The pxa2xx_spi driver supports both DMA and interrupt driven PIO message transfers. The driver defaults to PIO mode and DMA transfers must be enabled -by setting the "enable_dma" flag in the "pxa2xx_spi_master" structure. The DMA +by setting the "enable_dma" flag in the "pxa2xx_spi_controller" structure. The DMA mode supports both coherent and stream based DMA mappings. The following logic is used to determine the type of I/O to be used on |