From 9e9dc7d9597bd6881b3e7ae6ae3d710319605c47 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Thu, 8 May 2014 23:16:34 +0200 Subject: mfd: stmpe: root out static GPIO and IRQ assignments The only platform using the STMPE expander now boots from device tree using all-dynamic GPIO and IRQ number assignments, so remove the mechanism to pass this from the device tree entirely. Signed-off-by: Linus Walleij --- drivers/gpio/gpio-stmpe.c | 18 +++++------------- 1 file changed, 5 insertions(+), 13 deletions(-) (limited to 'drivers/gpio') diff --git a/drivers/gpio/gpio-stmpe.c b/drivers/gpio/gpio-stmpe.c index 2776a09bee58..628b58494294 100644 --- a/drivers/gpio/gpio-stmpe.c +++ b/drivers/gpio/gpio-stmpe.c @@ -23,7 +23,8 @@ enum { REG_RE, REG_FE, REG_IE }; #define CACHE_NR_REGS 3 -#define CACHE_NR_BANKS (STMPE_NR_GPIOS / 8) +/* No variant has more than 24 GPIOs */ +#define CACHE_NR_BANKS (24 / 8) struct stmpe_gpio { struct gpio_chip chip; @@ -31,8 +32,6 @@ struct stmpe_gpio { struct device *dev; struct mutex irq_lock; struct irq_domain *domain; - - int irq_base; unsigned norequest_mask; /* Caches of interrupt control registers for bus_lock */ @@ -311,13 +310,8 @@ static const struct irq_domain_ops stmpe_gpio_irq_simple_ops = { static int stmpe_gpio_irq_init(struct stmpe_gpio *stmpe_gpio, struct device_node *np) { - int base = 0; - - if (!np) - base = stmpe_gpio->irq_base; - stmpe_gpio->domain = irq_domain_add_simple(np, - stmpe_gpio->chip.ngpio, base, + stmpe_gpio->chip.ngpio, 0, &stmpe_gpio_irq_simple_ops, stmpe_gpio); if (!stmpe_gpio->domain) { dev_err(stmpe_gpio->dev, "failed to create irqdomain\n"); @@ -354,7 +348,7 @@ static int stmpe_gpio_probe(struct platform_device *pdev) #ifdef CONFIG_OF stmpe_gpio->chip.of_node = np; #endif - stmpe_gpio->chip.base = pdata ? pdata->gpio_base : -1; + stmpe_gpio->chip.base = -1; if (pdata) stmpe_gpio->norequest_mask = pdata->norequest_mask; @@ -362,9 +356,7 @@ static int stmpe_gpio_probe(struct platform_device *pdev) of_property_read_u32(np, "st,norequest-mask", &stmpe_gpio->norequest_mask); - if (irq >= 0) - stmpe_gpio->irq_base = stmpe->irq_base + STMPE_INT_GPIO(0); - else + if (irq < 0) dev_info(&pdev->dev, "device configured in no-irq mode; " "irqs are not available\n"); -- cgit v1.2.3