summaryrefslogtreecommitdiff
path: root/drivers/net/e1000e/netdev.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/net/e1000e/netdev.c')
-rw-r--r--drivers/net/e1000e/netdev.c87
1 files changed, 49 insertions, 38 deletions
diff --git a/drivers/net/e1000e/netdev.c b/drivers/net/e1000e/netdev.c
index 88d54d3efcef..dbf81788bb40 100644
--- a/drivers/net/e1000e/netdev.c
+++ b/drivers/net/e1000e/netdev.c
@@ -36,6 +36,7 @@
#include <linux/netdevice.h>
#include <linux/tcp.h>
#include <linux/ipv6.h>
+#include <linux/slab.h>
#include <net/checksum.h>
#include <net/ip6_checksum.h>
#include <linux/mii.h>
@@ -660,6 +661,8 @@ static bool e1000_clean_tx_irq(struct e1000_adapter *adapter)
i = 0;
}
+ if (i == tx_ring->next_to_use)
+ break;
eop = tx_ring->buffer_info[i].next_to_watch;
eop_desc = E1000_TX_DESC(*tx_ring, eop);
}
@@ -2289,8 +2292,6 @@ static void e1000_configure_tx(struct e1000_adapter *adapter)
ew32(TCTL, tctl);
e1000e_config_collision_dist(hw);
-
- adapter->tx_queue_len = adapter->netdev->tx_queue_len;
}
/**
@@ -2877,7 +2878,6 @@ void e1000e_down(struct e1000_adapter *adapter)
del_timer_sync(&adapter->watchdog_timer);
del_timer_sync(&adapter->phy_info_timer);
- netdev->tx_queue_len = adapter->tx_queue_len;
netif_carrier_off(netdev);
adapter->link_speed = 0;
adapter->link_duplex = 0;
@@ -3588,21 +3588,15 @@ static void e1000_watchdog_task(struct work_struct *work)
"link gets many collisions.\n");
}
- /*
- * tweak tx_queue_len according to speed/duplex
- * and adjust the timeout factor
- */
- netdev->tx_queue_len = adapter->tx_queue_len;
+ /* adjust timeout factor according to speed/duplex */
adapter->tx_timeout_factor = 1;
switch (adapter->link_speed) {
case SPEED_10:
txb2b = 0;
- netdev->tx_queue_len = 10;
adapter->tx_timeout_factor = 16;
break;
case SPEED_100:
txb2b = 0;
- netdev->tx_queue_len = 100;
adapter->tx_timeout_factor = 10;
break;
}
@@ -4289,6 +4283,14 @@ static int e1000_change_mtu(struct net_device *netdev, int new_mtu)
return -EINVAL;
}
+ /* 82573 Errata 17 */
+ if (((adapter->hw.mac.type == e1000_82573) ||
+ (adapter->hw.mac.type == e1000_82574)) &&
+ (max_frame > ETH_FRAME_LEN + ETH_FCS_LEN)) {
+ adapter->flags2 |= FLAG2_DISABLE_ASPM_L1;
+ e1000e_disable_aspm(adapter->pdev, PCIE_LINK_STATE_L1);
+ }
+
while (test_and_set_bit(__E1000_RESETTING, &adapter->state))
msleep(1);
/* e1000e_down -> e1000e_reset dependent on max_frame_size & mtu */
@@ -4611,29 +4613,42 @@ static void e1000_complete_shutdown(struct pci_dev *pdev, bool sleep,
}
}
-static void e1000e_disable_l1aspm(struct pci_dev *pdev)
+#ifdef CONFIG_PCIEASPM
+static void __e1000e_disable_aspm(struct pci_dev *pdev, u16 state)
+{
+ pci_disable_link_state(pdev, state);
+}
+#else
+static void __e1000e_disable_aspm(struct pci_dev *pdev, u16 state)
{
int pos;
- u16 val;
+ u16 reg16;
/*
- * 82573 workaround - disable L1 ASPM on mobile chipsets
- *
- * L1 ASPM on various mobile (ich7) chipsets do not behave properly
- * resulting in lost data or garbage information on the pci-e link
- * level. This could result in (false) bad EEPROM checksum errors,
- * long ping times (up to 2s) or even a system freeze/hang.
- *
- * Unfortunately this feature saves about 1W power consumption when
- * active.
+ * Both device and parent should have the same ASPM setting.
+ * Disable ASPM in downstream component first and then upstream.
*/
- pos = pci_find_capability(pdev, PCI_CAP_ID_EXP);
- pci_read_config_word(pdev, pos + PCI_EXP_LNKCTL, &val);
- if (val & 0x2) {
- dev_warn(&pdev->dev, "Disabling L1 ASPM\n");
- val &= ~0x2;
- pci_write_config_word(pdev, pos + PCI_EXP_LNKCTL, val);
- }
+ pos = pci_pcie_cap(pdev);
+ pci_read_config_word(pdev, pos + PCI_EXP_LNKCTL, &reg16);
+ reg16 &= ~state;
+ pci_write_config_word(pdev, pos + PCI_EXP_LNKCTL, reg16);
+
+ if (!pdev->bus->self)
+ return;
+
+ pos = pci_pcie_cap(pdev->bus->self);
+ pci_read_config_word(pdev->bus->self, pos + PCI_EXP_LNKCTL, &reg16);
+ reg16 &= ~state;
+ pci_write_config_word(pdev->bus->self, pos + PCI_EXP_LNKCTL, reg16);
+}
+#endif
+void e1000e_disable_aspm(struct pci_dev *pdev, u16 state)
+{
+ dev_info(&pdev->dev, "Disabling ASPM %s %s\n",
+ (state & PCIE_LINK_STATE_L0S) ? "L0s" : "",
+ (state & PCIE_LINK_STATE_L1) ? "L1" : "");
+
+ __e1000e_disable_aspm(pdev, state);
}
#ifdef CONFIG_PM
@@ -4659,7 +4674,8 @@ static int e1000_resume(struct pci_dev *pdev)
pci_set_power_state(pdev, PCI_D0);
pci_restore_state(pdev);
pci_save_state(pdev);
- e1000e_disable_l1aspm(pdev);
+ if (adapter->flags2 & FLAG2_DISABLE_ASPM_L1)
+ e1000e_disable_aspm(pdev, PCIE_LINK_STATE_L1);
err = pci_enable_device_mem(pdev);
if (err) {
@@ -4801,7 +4817,8 @@ static pci_ers_result_t e1000_io_slot_reset(struct pci_dev *pdev)
int err;
pci_ers_result_t result;
- e1000e_disable_l1aspm(pdev);
+ if (adapter->flags2 & FLAG2_DISABLE_ASPM_L1)
+ e1000e_disable_aspm(pdev, PCIE_LINK_STATE_L1);
err = pci_enable_device_mem(pdev);
if (err) {
dev_err(&pdev->dev,
@@ -4895,13 +4912,6 @@ static void e1000_eeprom_checks(struct e1000_adapter *adapter)
dev_warn(&adapter->pdev->dev,
"Warning: detected DSPD enabled in EEPROM\n");
}
-
- ret_val = e1000_read_nvm(hw, NVM_INIT_3GIO_3, 1, &buf);
- if (!ret_val && (le16_to_cpu(buf) & (3 << 2))) {
- /* ASPM enable */
- dev_warn(&adapter->pdev->dev,
- "Warning: detected ASPM enabled in EEPROM\n");
- }
}
static const struct net_device_ops e1000e_netdev_ops = {
@@ -4950,7 +4960,8 @@ static int __devinit e1000_probe(struct pci_dev *pdev,
u16 eeprom_data = 0;
u16 eeprom_apme_mask = E1000_EEPROM_APME;
- e1000e_disable_l1aspm(pdev);
+ if (ei->flags2 & FLAG2_DISABLE_ASPM_L1)
+ e1000e_disable_aspm(pdev, PCIE_LINK_STATE_L1);
err = pci_enable_device_mem(pdev);
if (err)
generated by cgit v1.2.3 (git 2.39.1) at 2024-12-24 07:31:44 +0000