diff options
Diffstat (limited to 'include/linux')
| -rw-r--r-- | include/linux/lcd.h | 3 | ||||
| -rw-r--r-- | include/linux/smc91x.h | 11 | ||||
| -rw-r--r-- | include/linux/spi/ads7846.h | 3 | ||||
| -rw-r--r-- | include/linux/spi/corgi_lcd.h | 20 | ||||
| -rw-r--r-- | include/linux/ucb1400.h | 161 | ||||
| -rw-r--r-- | include/linux/wm97xx_batt.h | 26 |
6 files changed, 224 insertions, 0 deletions
diff --git a/include/linux/lcd.h b/include/linux/lcd.h index 173febac6656..c67fecafff90 100644 --- a/include/linux/lcd.h +++ b/include/linux/lcd.h @@ -11,6 +11,7 @@ #include <linux/device.h> #include <linux/mutex.h> #include <linux/notifier.h> +#include <linux/fb.h> /* Notes on locking: * @@ -45,6 +46,8 @@ struct lcd_ops { int (*get_contrast)(struct lcd_device *); /* Set LCD panel contrast */ int (*set_contrast)(struct lcd_device *, int contrast); + /* Set LCD panel mode (resolutions ...) */ + int (*set_mode)(struct lcd_device *, struct fb_videomode *); /* Check if given framebuffer device is the one LCD is bound to; return 0 if not, !=0 if it is. If NULL, lcd always matches the fb. */ int (*check_fb)(struct lcd_device *, struct fb_info *); diff --git a/include/linux/smc91x.h b/include/linux/smc91x.h index 3827b922ba1f..bc21db598c06 100644 --- a/include/linux/smc91x.h +++ b/include/linux/smc91x.h @@ -16,8 +16,19 @@ #define SMC91X_USE_DMA (1 << 6) +#define RPC_LED_100_10 (0x00) /* LED = 100Mbps OR's with 10Mbps link detect */ +#define RPC_LED_RES (0x01) /* LED = Reserved */ +#define RPC_LED_10 (0x02) /* LED = 10Mbps link detect */ +#define RPC_LED_FD (0x03) /* LED = Full Duplex Mode */ +#define RPC_LED_TX_RX (0x04) /* LED = TX or RX packet occurred */ +#define RPC_LED_100 (0x05) /* LED = 100Mbps link dectect */ +#define RPC_LED_TX (0x06) /* LED = TX packet occurred */ +#define RPC_LED_RX (0x07) /* LED = RX packet occurred */ + struct smc91x_platdata { unsigned long flags; + unsigned char leda; + unsigned char ledb; }; #endif /* __SMC91X_H__ */ diff --git a/include/linux/spi/ads7846.h b/include/linux/spi/ads7846.h index daf744017a31..05eab2f11e63 100644 --- a/include/linux/spi/ads7846.h +++ b/include/linux/spi/ads7846.h @@ -43,6 +43,9 @@ struct ads7846_platform_data { u16 debounce_tol; /* tolerance used for filtering */ u16 debounce_rep; /* additional consecutive good readings * required after the first two */ + int gpio_pendown; /* the GPIO used to decide the pendown + * state if get_pendown_state == NULL + */ int (*get_pendown_state)(void); int (*filter_init) (struct ads7846_platform_data *pdata, void **filter_data); diff --git a/include/linux/spi/corgi_lcd.h b/include/linux/spi/corgi_lcd.h new file mode 100644 index 000000000000..6692b3418ccf --- /dev/null +++ b/include/linux/spi/corgi_lcd.h @@ -0,0 +1,20 @@ +#ifndef __LINUX_SPI_CORGI_LCD_H +#define __LINUX_SPI_CORGI_LCD_H + +#define CORGI_LCD_MODE_QVGA 1 +#define CORGI_LCD_MODE_VGA 2 + +struct corgi_lcd_platform_data { + int init_mode; + int max_intensity; + int default_intensity; + int limit_mask; + + int gpio_backlight_on; /* -1 if n/a */ + int gpio_backlight_cont; /* -1 if n/a */ + + void (*notify)(int intensity); + void (*kick_battery)(void); +}; + +#endif /* __LINUX_SPI_CORGI_LCD_H */ diff --git a/include/linux/ucb1400.h b/include/linux/ucb1400.h new file mode 100644 index 000000000000..970473bf8d5a --- /dev/null +++ b/include/linux/ucb1400.h @@ -0,0 +1,161 @@ +/* + * Register definitions and functions for: + * Philips UCB1400 driver + * + * Based on ucb1400_ts: + * Author: Nicolas Pitre + * Created: September 25, 2006 + * Copyright: MontaVista Software, Inc. + * + * Spliting done by: Marek Vasut <marek.vasut@gmail.com> + * If something doesnt work and it worked before spliting, e-mail me, + * dont bother Nicolas please ;-) + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License version 2 as + * published by the Free Software Foundation. + * + * This code is heavily based on ucb1x00-*.c copyrighted by Russell King + * covering the UCB1100, UCB1200 and UCB1300.. Support for the UCB1400 has + * been made separate from ucb1x00-core/ucb1x00-ts on Russell's request. + */ + +#ifndef _LINUX__UCB1400_H +#define _LINUX__UCB1400_H + +#include <sound/ac97_codec.h> +#include <linux/mutex.h> +#include <linux/platform_device.h> + +/* + * UCB1400 AC-link registers + */ + +#define UCB_IO_DATA 0x5a +#define UCB_IO_DIR 0x5c +#define UCB_IE_RIS 0x5e +#define UCB_IE_FAL 0x60 +#define UCB_IE_STATUS 0x62 +#define UCB_IE_CLEAR 0x62 +#define UCB_IE_ADC (1 << 11) +#define UCB_IE_TSPX (1 << 12) + +#define UCB_TS_CR 0x64 +#define UCB_TS_CR_TSMX_POW (1 << 0) +#define UCB_TS_CR_TSPX_POW (1 << 1) +#define UCB_TS_CR_TSMY_POW (1 << 2) +#define UCB_TS_CR_TSPY_POW (1 << 3) +#define UCB_TS_CR_TSMX_GND (1 << 4) +#define UCB_TS_CR_TSPX_GND (1 << 5) +#define UCB_TS_CR_TSMY_GND (1 << 6) +#define UCB_TS_CR_TSPY_GND (1 << 7) +#define UCB_TS_CR_MODE_INT (0 << 8) +#define UCB_TS_CR_MODE_PRES (1 << 8) +#define UCB_TS_CR_MODE_POS (2 << 8) +#define UCB_TS_CR_BIAS_ENA (1 << 11) +#define UCB_TS_CR_TSPX_LOW (1 << 12) +#define UCB_TS_CR_TSMX_LOW (1 << 13) + +#define UCB_ADC_CR 0x66 +#define UCB_ADC_SYNC_ENA (1 << 0) +#define UCB_ADC_VREFBYP_CON (1 << 1) +#define UCB_ADC_INP_TSPX (0 << 2) +#define UCB_ADC_INP_TSMX (1 << 2) +#define UCB_ADC_INP_TSPY (2 << 2) +#define UCB_ADC_INP_TSMY (3 << 2) +#define UCB_ADC_INP_AD0 (4 << 2) +#define UCB_ADC_INP_AD1 (5 << 2) +#define UCB_ADC_INP_AD2 (6 << 2) +#define UCB_ADC_INP_AD3 (7 << 2) +#define UCB_ADC_EXT_REF (1 << 5) +#define UCB_ADC_START (1 << 7) +#define UCB_ADC_ENA (1 << 15) + +#define UCB_ADC_DATA 0x68 +#define UCB_ADC_DAT_VALID (1 << 15) +#define UCB_ADC_DAT_MASK 0x3ff + +#define UCB_ID 0x7e +#define UCB_ID_1400 0x4304 + +struct ucb1400_ts { + struct input_dev *ts_idev; + struct task_struct *ts_task; + int id; + wait_queue_head_t ts_wait; + unsigned int ts_restart:1; + int irq; + unsigned int irq_pending; /* not bit field shared */ + struct snd_ac97 *ac97; +}; + +struct ucb1400 { + struct platform_device *ucb1400_ts; +}; + +static inline u16 ucb1400_reg_read(struct snd_ac97 *ac97, u16 reg) +{ + return ac97->bus->ops->read(ac97, reg); +} + +static inline void ucb1400_reg_write(struct snd_ac97 *ac97, u16 reg, u16 val) +{ + ac97->bus->ops->write(ac97, reg, val); +} + +static inline u16 ucb1400_gpio_get_value(struct snd_ac97 *ac97, u16 gpio) +{ + return ucb1400_reg_read(ac97, UCB_IO_DATA) & (1 << gpio); +} + +static inline void ucb1400_gpio_set_value(struct snd_ac97 *ac97, u16 gpio, + u16 val) +{ + ucb1400_reg_write(ac97, UCB_IO_DATA, val ? + ucb1400_reg_read(ac97, UCB_IO_DATA) | (1 << gpio) : + ucb1400_reg_read(ac97, UCB_IO_DATA) & ~(1 << gpio)); +} + +static inline u16 ucb1400_gpio_get_direction(struct snd_ac97 *ac97, u16 gpio) +{ + return ucb1400_reg_read(ac97, UCB_IO_DIR) & (1 << gpio); +} + +static inline void ucb1400_gpio_set_direction(struct snd_ac97 *ac97, u16 gpio, + u16 dir) +{ + ucb1400_reg_write(ac97, UCB_IO_DIR, dir ? + ucb1400_reg_read(ac97, UCB_IO_DIR) | (1 << gpio) : + ucb1400_reg_read(ac97, UCB_IO_DIR) & ~(1 << gpio)); +} + +static inline void ucb1400_adc_enable(struct snd_ac97 *ac97) +{ + ucb1400_reg_write(ac97, UCB_ADC_CR, UCB_ADC_ENA); +} + +static unsigned int ucb1400_adc_read(struct snd_ac97 *ac97, u16 adc_channel, + int adcsync) +{ + unsigned int val; + + if (adcsync) + adc_channel |= UCB_ADC_SYNC_ENA; + + ucb1400_reg_write(ac97, UCB_ADC_CR, UCB_ADC_ENA | adc_channel); + ucb1400_reg_write(ac97, UCB_ADC_CR, UCB_ADC_ENA | adc_channel | + UCB_ADC_START); + + while (!((val = ucb1400_reg_read(ac97, UCB_ADC_DATA)) + & UCB_ADC_DAT_VALID)) + schedule_timeout_uninterruptible(1); + + return val & UCB_ADC_DAT_MASK; +} + +static inline void ucb1400_adc_disable(struct snd_ac97 *ac97) +{ + ucb1400_reg_write(ac97, UCB_ADC_CR, 0); +} + +#endif diff --git a/include/linux/wm97xx_batt.h b/include/linux/wm97xx_batt.h new file mode 100644 index 000000000000..9681d1ab0e4f --- /dev/null +++ b/include/linux/wm97xx_batt.h @@ -0,0 +1,26 @@ +#ifndef _LINUX_WM97XX_BAT_H +#define _LINUX_WM97XX_BAT_H + +#include <linux/wm97xx.h> + +struct wm97xx_batt_info { + int batt_aux; + int temp_aux; + int charge_gpio; + int min_voltage; + int max_voltage; + int batt_div; + int batt_mult; + int temp_div; + int temp_mult; + int batt_tech; + char *batt_name; +}; + +#ifdef CONFIG_BATTERY_WM97XX +void __init wm97xx_bat_set_pdata(struct wm97xx_batt_info *data); +#else +static inline void wm97xx_bat_set_pdata(struct wm97xx_batt_info *data) {} +#endif + +#endif |