diff options
Diffstat (limited to 'drivers/net/wireless/zd1211rw/zd_chip.h')
| -rw-r--r-- | drivers/net/wireless/zd1211rw/zd_chip.h | 104 |
1 files changed, 63 insertions, 41 deletions
diff --git a/drivers/net/wireless/zd1211rw/zd_chip.h b/drivers/net/wireless/zd1211rw/zd_chip.h index ae59597ce4e1..ca892b9a6448 100644 --- a/drivers/net/wireless/zd1211rw/zd_chip.h +++ b/drivers/net/wireless/zd1211rw/zd_chip.h @@ -337,24 +337,24 @@ #define CR_MAC_PS_STATE CTL_REG(0x050C) #define CR_INTERRUPT CTL_REG(0x0510) -#define INT_TX_COMPLETE 0x00000001 -#define INT_RX_COMPLETE 0x00000002 -#define INT_RETRY_FAIL 0x00000004 -#define INT_WAKEUP 0x00000008 -#define INT_DTIM_NOTIFY 0x00000020 -#define INT_CFG_NEXT_BCN 0x00000040 -#define INT_BUS_ABORT 0x00000080 -#define INT_TX_FIFO_READY 0x00000100 -#define INT_UART 0x00000200 -#define INT_TX_COMPLETE_EN 0x00010000 -#define INT_RX_COMPLETE_EN 0x00020000 -#define INT_RETRY_FAIL_EN 0x00040000 -#define INT_WAKEUP_EN 0x00080000 -#define INT_DTIM_NOTIFY_EN 0x00200000 -#define INT_CFG_NEXT_BCN_EN 0x00400000 -#define INT_BUS_ABORT_EN 0x00800000 -#define INT_TX_FIFO_READY_EN 0x01000000 -#define INT_UART_EN 0x02000000 +#define INT_TX_COMPLETE (1 << 0) +#define INT_RX_COMPLETE (1 << 1) +#define INT_RETRY_FAIL (1 << 2) +#define INT_WAKEUP (1 << 3) +#define INT_DTIM_NOTIFY (1 << 5) +#define INT_CFG_NEXT_BCN (1 << 6) +#define INT_BUS_ABORT (1 << 7) +#define INT_TX_FIFO_READY (1 << 8) +#define INT_UART (1 << 9) +#define INT_TX_COMPLETE_EN (1 << 16) +#define INT_RX_COMPLETE_EN (1 << 17) +#define INT_RETRY_FAIL_EN (1 << 18) +#define INT_WAKEUP_EN (1 << 19) +#define INT_DTIM_NOTIFY_EN (1 << 21) +#define INT_CFG_NEXT_BCN_EN (1 << 22) +#define INT_BUS_ABORT_EN (1 << 23) +#define INT_TX_FIFO_READY_EN (1 << 24) +#define INT_UART_EN (1 << 25) #define CR_TSF_LOW_PART CTL_REG(0x0514) #define CR_TSF_HIGH_PART CTL_REG(0x0518) @@ -398,18 +398,18 @@ * device will use a rate in this table that is less than or equal to the rate * of the incoming frame which prompted the response */ #define CR_BASIC_RATE_TBL CTL_REG(0x0630) -#define CR_RATE_1M 0x0001 /* 802.11b */ -#define CR_RATE_2M 0x0002 /* 802.11b */ -#define CR_RATE_5_5M 0x0004 /* 802.11b */ -#define CR_RATE_11M 0x0008 /* 802.11b */ -#define CR_RATE_6M 0x0100 /* 802.11g */ -#define CR_RATE_9M 0x0200 /* 802.11g */ -#define CR_RATE_12M 0x0400 /* 802.11g */ -#define CR_RATE_18M 0x0800 /* 802.11g */ -#define CR_RATE_24M 0x1000 /* 802.11g */ -#define CR_RATE_36M 0x2000 /* 802.11g */ -#define CR_RATE_48M 0x4000 /* 802.11g */ -#define CR_RATE_54M 0x8000 /* 802.11g */ +#define CR_RATE_1M (1 << 0) /* 802.11b */ +#define CR_RATE_2M (1 << 1) /* 802.11b */ +#define CR_RATE_5_5M (1 << 2) /* 802.11b */ +#define CR_RATE_11M (1 << 3) /* 802.11b */ +#define CR_RATE_6M (1 << 8) /* 802.11g */ +#define CR_RATE_9M (1 << 9) /* 802.11g */ +#define CR_RATE_12M (1 << 10) /* 802.11g */ +#define CR_RATE_18M (1 << 11) /* 802.11g */ +#define CR_RATE_24M (1 << 12) /* 802.11g */ +#define CR_RATE_36M (1 << 13) /* 802.11g */ +#define CR_RATE_48M (1 << 14) /* 802.11g */ +#define CR_RATE_54M (1 << 15) /* 802.11g */ #define CR_RATES_80211G 0xff00 #define CR_RATES_80211B 0x000f @@ -420,15 +420,24 @@ #define CR_MANDATORY_RATE_TBL CTL_REG(0x0634) #define CR_RTS_CTS_RATE CTL_REG(0x0638) +/* These are all bit indexes in CR_RTS_CTS_RATE, so remember to shift. */ +#define RTSCTS_SH_RTS_RATE 0 +#define RTSCTS_SH_EXP_CTS_RATE 4 +#define RTSCTS_SH_RTS_MOD_TYPE 8 +#define RTSCTS_SH_RTS_PMB_TYPE 9 +#define RTSCTS_SH_CTS_RATE 16 +#define RTSCTS_SH_CTS_MOD_TYPE 24 +#define RTSCTS_SH_CTS_PMB_TYPE 25 + #define CR_WEP_PROTECT CTL_REG(0x063C) #define CR_RX_THRESHOLD CTL_REG(0x0640) /* register for controlling the LEDS */ #define CR_LED CTL_REG(0x0644) /* masks for controlling LEDs */ -#define LED1 0x0100 -#define LED2 0x0200 -#define LED_SW 0x0400 +#define LED1 (1 << 8) +#define LED2 (1 << 9) +#define LED_SW (1 << 10) /* Seems to indicate that the configuration is over. */ @@ -455,18 +464,18 @@ * registers, so one could argue it is a LOCK bit. But calling it * LOCK_PHY_REGS makes it confusing. */ -#define UNLOCK_PHY_REGS 0x0080 +#define UNLOCK_PHY_REGS (1 << 7) #define CR_DEVICE_STATE CTL_REG(0x0684) #define CR_UNDERRUN_CNT CTL_REG(0x0688) #define CR_RX_FILTER CTL_REG(0x068c) -#define RX_FILTER_ASSOC_RESPONSE 0x0002 -#define RX_FILTER_REASSOC_RESPONSE 0x0008 -#define RX_FILTER_PROBE_RESPONSE 0x0020 -#define RX_FILTER_BEACON 0x0100 -#define RX_FILTER_DISASSOC 0x0400 -#define RX_FILTER_AUTH 0x0800 +#define RX_FILTER_ASSOC_RESPONSE (1 << 1) +#define RX_FILTER_REASSOC_RESPONSE (1 << 3) +#define RX_FILTER_PROBE_RESPONSE (1 << 5) +#define RX_FILTER_BEACON (1 << 8) +#define RX_FILTER_DISASSOC (1 << 10) +#define RX_FILTER_AUTH (1 << 11) #define AP_RX_FILTER 0x0400feff #define STA_RX_FILTER 0x0000ffff @@ -794,6 +803,9 @@ void zd_chip_disable_rx(struct zd_chip *chip); int zd_chip_enable_hwint(struct zd_chip *chip); int zd_chip_disable_hwint(struct zd_chip *chip); +int zd_chip_set_rts_cts_rate_locked(struct zd_chip *chip, + u8 rts_rate, int preamble); + static inline int zd_get_encryption_type(struct zd_chip *chip, u32 *type) { return zd_ioread32(chip, CR_ENCRYPTION_TYPE, type); @@ -809,7 +821,17 @@ static inline int zd_chip_get_basic_rates(struct zd_chip *chip, u16 *cr_rates) return zd_ioread16(chip, CR_BASIC_RATE_TBL, cr_rates); } -int zd_chip_set_basic_rates(struct zd_chip *chip, u16 cr_rates); +int zd_chip_set_basic_rates_locked(struct zd_chip *chip, u16 cr_rates); + +static inline int zd_chip_set_basic_rates(struct zd_chip *chip, u16 cr_rates) +{ + int r; + + mutex_lock(&chip->mutex); + r = zd_chip_set_basic_rates_locked(chip, cr_rates); + mutex_unlock(&chip->mutex); + return r; +} static inline int zd_chip_set_rx_filter(struct zd_chip *chip, u32 filter) { |