diff options
| author | David Ertman <davidx.m.ertman@intel.com> | 2014-02-22 03:15:17 +0000 |
|---|---|---|
| committer | Jeff Kirsher <jeffrey.t.kirsher@intel.com> | 2014-03-07 22:52:07 -0800 |
| commit | 74f350ee08e2ffa083204029018fce9941ba9bd5 (patch) | |
| tree | d162e3f02341b9f8d83a9d30b328a766b35551c5 /drivers/net/ethernet/intel/e1000e/regs.h | |
| parent | 63eb48f151b5f1d8dba35d6176d0d7c9643b33af (diff) | |
e1000e: Feature Enable PHY Ultra Low Power Mode (ULP)
ULP is a power saving feature that reduces the power consumption of the
PHY when a cable is not connected.
ULP is gated on the following conditions:
1) The hardware must support ULP. Currently this is only I218
devices from Intel
2) ULP is initiated by the driver, so, no driver results in no ULP.
3) ULP's implementation utilizes Runtime Power Management to toggle its
execution. ULP is enabled/disabled based on the state of Runtime PM.
4) ULP is not active when wake-on-unicast, multicast or broadcast is active
as these features are mutually-exclusive.
Since the PHY is in an unavailable state while ULP is active, any access
of the PHY registers will fail. This is resolved by utilizing kernel
calls that cause the device to exit Runtime PM (e.g. pm_runtime_get_sync)
and then, after PHY access is complete, allow the device to resume
Runtime PM (e.g. pm_runtime_put_sync).
Under certain conditions, toggling the LANPHYPC is necessary to disable
ULP mode. Break out existing code to toggle LANPHYPC to a new function
to avoid code duplication.
Signed-off-by: Dave Ertman <davidx.m.ertman@intel.com>
Cc: Bruce Allan <bruce.w.allan@intel.com>
Tested-by: Jeff Pieper <jeffrey.e.pieper@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Diffstat (limited to 'drivers/net/ethernet/intel/e1000e/regs.h')
| -rw-r--r-- | drivers/net/ethernet/intel/e1000e/regs.h | 1 |
1 files changed, 1 insertions, 0 deletions
diff --git a/drivers/net/ethernet/intel/e1000e/regs.h b/drivers/net/ethernet/intel/e1000e/regs.h index 5c55ef348fc2..ea235bbe50d3 100644 --- a/drivers/net/ethernet/intel/e1000e/regs.h +++ b/drivers/net/ethernet/intel/e1000e/regs.h @@ -32,6 +32,7 @@ #define E1000_SCTL 0x00024 /* SerDes Control - RW */ #define E1000_FCAL 0x00028 /* Flow Control Address Low - RW */ #define E1000_FCAH 0x0002C /* Flow Control Address High -RW */ +#define E1000_FEXT 0x0002C /* Future Extended - RW */ #define E1000_FEXTNVM 0x00028 /* Future Extended NVM - RW */ #define E1000_FEXTNVM3 0x0003C /* Future Extended NVM 3 - RW */ #define E1000_FEXTNVM4 0x00024 /* Future Extended NVM 4 - RW */ |