From 90950a2504b66d626a73f55ca949a2e79ff4b7c4 Mon Sep 17 00:00:00 2001 From: Robert Hancock Date: Sat, 12 Sep 2009 23:54:47 -0600 Subject: pata_amd: do not filter out valid modes in nv_mode_filter On a Compaq Presario V3000 laptop (NVIDIA MCP51 chipset), pata_amd selects PIO0 mode for the PATA DVD-RAM drive instead of MWDMA2 which it supports: ata4.00: ATAPI: HL-DT-ST DVDRAM GSA-4084N, KQ09, max MWDMA2 ata4: nv_mode_filter: 0x39f&0x7001->0x1, BIOS=0x0 (0x0) ACPI=0x7001 (60:600:0x11) ata4.00: configured for PIO0 For some reason, the BIOS-set UDMA configuration returns 0 and the ACPI _GTM reports that UDMA2 and PIO0 are enabled. This causes nv_mode_filter to end up allowing only PIO0 and UDMA0-2. Since the drive doesn't support UDMA we end up using PIO0. Since the controllers should always support PIO4, MWDMA2 and UDMA2 regardless of what cable type is used, let's make sure we don't filter out these modes regardless of what wacky settings the BIOS is using. Signed-off-by: Robert Hancock Cc: stable@kernel.org Signed-off-by: Jeff Garzik --- drivers/ata/pata_amd.c | 3 +++ 1 file changed, 3 insertions(+) (limited to 'drivers/ata/pata_amd.c') diff --git a/drivers/ata/pata_amd.c b/drivers/ata/pata_amd.c index 33a74f11171c..567f3f72774e 100644 --- a/drivers/ata/pata_amd.c +++ b/drivers/ata/pata_amd.c @@ -307,6 +307,9 @@ static unsigned long nv_mode_filter(struct ata_device *dev, limit |= ATA_MASK_PIO; if (!(limit & (ATA_MASK_MWDMA | ATA_MASK_UDMA))) limit |= ATA_MASK_MWDMA | ATA_MASK_UDMA; + /* PIO4, MWDMA2, UDMA2 should always be supported regardless of + cable detection result */ + limit |= ata_pack_xfermask(ATA_PIO4, ATA_MWDMA2, ATA_UDMA2); ata_port_printk(ap, KERN_DEBUG, "nv_mode_filter: 0x%lx&0x%lx->0x%lx, " "BIOS=0x%lx (0x%x) ACPI=0x%lx%s\n", -- cgit v1.2.3