From 690f44badf2f44b8ec09098118b74f789f95e2c8 Mon Sep 17 00:00:00 2001 From: Paul Kocialkowski Date: Fri, 5 Feb 2016 19:42:18 +0100 Subject: regulator: lp872x: Remove warning about invalid DVS GPIO Some devices don't hook the DVS pin to a GPIO but to ground or VCC. In those cases, it is not a problem to have no DVS GPIO provided, as the current code will already switch to software-only DVS selection: When the DVS GPIO is invalid, lp872x_init_dvs jumps to the set_default_dvs_mode label, which instructs the chip not to use the DVS pin at all and do it all in software instead (by clearing the LP8720_EXT_DVS_M bit in the LP872X_GENERAL_CFG register). That is reflected later in the code, when setting the bucks (the DVS pin only applies to the bucks) by checking for the LP8720_EXT_DVS_M bit on the LP872X_GENERAL_CFG register (in lp872x_select_buck_vout_addr) to decide whether to use software or hardware DVS selection. Thus, there is no need to print a warning when the DVS GPIO is invalid. Signed-off-by: Paul Kocialkowski Signed-off-by: Mark Brown --- drivers/regulator/lp872x.c | 4 +--- 1 file changed, 1 insertion(+), 3 deletions(-) (limited to 'drivers/regulator/lp872x.c') diff --git a/drivers/regulator/lp872x.c b/drivers/regulator/lp872x.c index 19d758486553..21c49d871aba 100644 --- a/drivers/regulator/lp872x.c +++ b/drivers/regulator/lp872x.c @@ -738,10 +738,8 @@ static int lp872x_init_dvs(struct lp872x *lp) goto set_default_dvs_mode; gpio = dvs->gpio; - if (!gpio_is_valid(gpio)) { - dev_warn(lp->dev, "invalid gpio: %d\n", gpio); + if (!gpio_is_valid(gpio)) goto set_default_dvs_mode; - } pinstate = dvs->init_state; ret = devm_gpio_request_one(lp->dev, gpio, pinstate, "LP872X DVS"); -- cgit v1.2.3