From 035fe03a7ad56982b30ab3a522b7b08d58feccd0 Mon Sep 17 00:00:00 2001 From: Josef Bacik Date: Wed, 27 Jan 2010 02:09:38 +0000 Subject: Btrfs: check total number of devices when removing missing If you have a disk failure in RAID1 and then add a new disk to the array, and then try to remove the missing volume, it will fail. The reason is the sanity check only looks at the total number of rw devices, which is just 2 because we have 2 good disks and 1 bad one. Instead check the total number of devices in the array to make sure we can actually remove the device. Tested this with a failed disk setup and with this test we can now run btrfs-vol -r missing /mount/point and it works fine. Signed-off-by: Josef Bacik Signed-off-by: Chris Mason --- fs/btrfs/volumes.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'fs/btrfs') diff --git a/fs/btrfs/volumes.c b/fs/btrfs/volumes.c index 5eb7459e3782..41ecbb2347f2 100644 --- a/fs/btrfs/volumes.c +++ b/fs/btrfs/volumes.c @@ -1135,7 +1135,7 @@ int btrfs_rm_device(struct btrfs_root *root, char *device_path) root->fs_info->avail_metadata_alloc_bits; if ((all_avail & BTRFS_BLOCK_GROUP_RAID10) && - root->fs_info->fs_devices->rw_devices <= 4) { + root->fs_info->fs_devices->num_devices <= 4) { printk(KERN_ERR "btrfs: unable to go below four devices " "on raid10\n"); ret = -EINVAL; @@ -1143,7 +1143,7 @@ int btrfs_rm_device(struct btrfs_root *root, char *device_path) } if ((all_avail & BTRFS_BLOCK_GROUP_RAID1) && - root->fs_info->fs_devices->rw_devices <= 2) { + root->fs_info->fs_devices->num_devices <= 2) { printk(KERN_ERR "btrfs: unable to go below two " "devices on raid1\n"); ret = -EINVAL; -- cgit v1.2.3