From e8fc721a9ab8dd6723063a92f5c5fdb5eaffbd6e Mon Sep 17 00:00:00 2001 From: Andrew Lunn Date: Fri, 28 Dec 2012 13:25:09 +0100 Subject: power/reset: Add a new driver to turn QNAP board power off The QNAP NAS boxes have a microcontroller attached to the SoCs second serial port. By sending it a simple command, it will turn the power for the board off. This driver registers a function for pm_power_off to send such a command. Signed-off-by: Andrew Lunn Signed-off-by: Anton Vorontsov --- drivers/power/reset/Kconfig | 9 +++++++++ 1 file changed, 9 insertions(+) (limited to 'drivers/power/reset/Kconfig') diff --git a/drivers/power/reset/Kconfig b/drivers/power/reset/Kconfig index 6461b489fb09..6453aac701c0 100644 --- a/drivers/power/reset/Kconfig +++ b/drivers/power/reset/Kconfig @@ -13,3 +13,12 @@ config POWER_RESET_GPIO This driver supports turning off your board via a GPIO line. If your board needs a GPIO high/low to power down, say Y and create a binding in your devicetree. + +config POWER_RESET_QNAP + bool "QNAP power-off driver" + depends on OF_GPIO && POWER_RESET && PLAT_ORION + help + This driver supports turning off QNAP NAS devices by sending + commands to the microcontroller which controls the main power. + + Say Y if you have a QNAP NAS. -- cgit v1.2.3