diff options
Diffstat (limited to 'include')
| -rw-r--r-- | include/linux/spi/spi.h | 8 | ||||
| -rw-r--r-- | include/linux/spi/spi_bitbang.h | 6 |
2 files changed, 14 insertions, 0 deletions
diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h index b05f1463a267..caa4665e3fa2 100644 --- a/include/linux/spi/spi.h +++ b/include/linux/spi/spi.h @@ -31,6 +31,7 @@ extern struct bus_type spi_bus_type; * @master: SPI controller used with the device. * @max_speed_hz: Maximum clock rate to be used with this chip * (on this board); may be changed by the device's driver. + * The spi_transfer.speed_hz can override this for each transfer. * @chip-select: Chipselect, distinguishing chips handled by "master". * @mode: The spi mode defines how data is clocked out and in. * This may be changed by the device's driver. @@ -38,6 +39,7 @@ extern struct bus_type spi_bus_type; * like eight or 12 bits are common. In-memory wordsizes are * powers of two bytes (e.g. 20 bit samples use 32 bits). * This may be changed by the device's driver. + * The spi_transfer.bits_per_word can override this for each transfer. * @irq: Negative, or the number passed to request_irq() to receive * interrupts from this device. * @controller_state: Controller's runtime state @@ -268,6 +270,10 @@ extern struct spi_master *spi_busnum_to_master(u16 busnum); * @tx_dma: DMA address of tx_buf, if spi_message.is_dma_mapped * @rx_dma: DMA address of rx_buf, if spi_message.is_dma_mapped * @len: size of rx and tx buffers (in bytes) + * @speed_hz: Select a speed other then the device default for this + * transfer. If 0 the default (from spi_device) is used. + * @bits_per_word: select a bits_per_word other then the device default + * for this transfer. If 0 the default (from spi_device) is used. * @cs_change: affects chipselect after this transfer completes * @delay_usecs: microseconds to delay after this transfer before * (optionally) changing the chipselect status, then starting @@ -322,7 +328,9 @@ struct spi_transfer { dma_addr_t rx_dma; unsigned cs_change:1; + u8 bits_per_word; u16 delay_usecs; + u32 speed_hz; struct list_head transfer_list; }; diff --git a/include/linux/spi/spi_bitbang.h b/include/linux/spi/spi_bitbang.h index c961fe9bf3eb..c954557b757c 100644 --- a/include/linux/spi/spi_bitbang.h +++ b/include/linux/spi/spi_bitbang.h @@ -30,6 +30,12 @@ struct spi_bitbang { struct spi_master *master; + /* setup_transfer() changes clock and/or wordsize to match settings + * for this transfer; zeroes restore defaults from spi_device. + */ + int (*setup_transfer)(struct spi_device *spi, + struct spi_transfer *t); + void (*chipselect)(struct spi_device *spi, int is_on); #define BITBANG_CS_ACTIVE 1 /* normally nCS, active low */ #define BITBANG_CS_INACTIVE 0 |