1 files changed, 0 insertions, 133 deletions
diff --git a/include/linux/mfd/tmio.h b/include/linux/mfd/tmio.h
deleted file mode 100644
index eace8ea6cda0..000000000000
--- a/include/linux/mfd/tmio.h
+++ /dev/null
@@ -1,133 +0,0 @@
-/* SPDX-License-Identifier: GPL-2.0 */
-#ifndef MFD_TMIO_H
-#define MFD_TMIO_H
-
-#include <linux/device.h>
-#include <linux/fb.h>
-#include <linux/io.h>
-#include <linux/jiffies.h>
-#include <linux/mmc/card.h>
-#include <linux/platform_device.h>
-#include <linux/pm_runtime.h>
-
-#define tmio_ioread8(addr) readb(addr)
-#define tmio_ioread16(addr) readw(addr)
-#define tmio_ioread16_rep(r, b, l) readsw(r, b, l)
-#define tmio_ioread32(addr) \
-	(((u32)readw((addr))) | (((u32)readw((addr) + 2)) << 16))
-
-#define tmio_iowrite8(val, addr) writeb((val), (addr))
-#define tmio_iowrite16(val, addr) writew((val), (addr))
-#define tmio_iowrite16_rep(r, b, l) writesw(r, b, l)
-#define tmio_iowrite32(val, addr) \
-	do { \
-		writew((val),       (addr)); \
-		writew((val) >> 16, (addr) + 2); \
-	} while (0)
-
-#define sd_config_write8(base, shift, reg, val) \
-	tmio_iowrite8((val), (base) + ((reg) << (shift)))
-#define sd_config_write16(base, shift, reg, val) \
-	tmio_iowrite16((val), (base) + ((reg) << (shift)))
-#define sd_config_write32(base, shift, reg, val) \
-	do { \
-		tmio_iowrite16((val), (base) + ((reg) << (shift)));   \
-		tmio_iowrite16((val) >> 16, (base) + ((reg + 2) << (shift))); \
-	} while (0)
-
-/* tmio MMC platform flags */
-/*
- * Some controllers can support a 2-byte block size when the bus width
- * is configured in 4-bit mode.
- */
-#define TMIO_MMC_BLKSZ_2BYTES		BIT(1)
-/*
- * Some controllers can support SDIO IRQ signalling.
- */
-#define TMIO_MMC_SDIO_IRQ		BIT(2)
-
-/* Some features are only available or tested on R-Car Gen2 or later */
-#define TMIO_MMC_MIN_RCAR2		BIT(3)
-
-/*
- * Some controllers require waiting for the SD bus to become
- * idle before writing to some registers.
- */
-#define TMIO_MMC_HAS_IDLE_WAIT		BIT(4)
-
-/*
- * Use the busy timeout feature. Probably all TMIO versions support it. Yet,
- * we don't have documentation for old variants, so we enable only known good
- * variants with this flag. Can be removed once all variants are known good.
- */
-#define TMIO_MMC_USE_BUSY_TIMEOUT	BIT(5)
-
-/*
- * Some controllers have CMD12 automatically
- * issue/non-issue register
- */
-#define TMIO_MMC_HAVE_CMD12_CTRL	BIT(7)
-
-/* Controller has some SDIO status bits which must be 1 */
-#define TMIO_MMC_SDIO_STATUS_SETBITS	BIT(8)
-
-/*
- * Some controllers have a 32-bit wide data port register
- */
-#define TMIO_MMC_32BIT_DATA_PORT	BIT(9)
-
-/*
- * Some controllers allows to set SDx actual clock
- */
-#define TMIO_MMC_CLK_ACTUAL		BIT(10)
-
-/* Some controllers have a CBSY bit */
-#define TMIO_MMC_HAVE_CBSY		BIT(11)
-
-struct dma_chan;
-
-/*
- * data for the MMC controller
- */
-struct tmio_mmc_data {
-	void				*chan_priv_tx;
-	void				*chan_priv_rx;
-	unsigned int			hclk;
-	unsigned long			capabilities;
-	unsigned long			capabilities2;
-	unsigned long			flags;
-	u32				ocr_mask;	/* available voltages */
-	dma_addr_t			dma_rx_offset;
-	unsigned int			max_blk_count;
-	unsigned short			max_segs;
-	void (*set_pwr)(struct platform_device *host, int state);
-	void (*set_clk_div)(struct platform_device *host, int state);
-};
-
-/*
- * data for the NAND controller
- */
-struct tmio_nand_data {
-	struct nand_bbt_descr	*badblock_pattern;
-	struct mtd_partition	*partition;
-	unsigned int		num_partitions;
-	const char *const	*part_parsers;
-};
-
-#define FBIO_TMIO_ACC_WRITE	0x7C639300
-#define FBIO_TMIO_ACC_SYNC	0x7C639301
-
-struct tmio_fb_data {
-	int			(*lcd_set_power)(struct platform_device *fb_dev,
-						 bool on);
-	int			(*lcd_mode)(struct platform_device *fb_dev,
-					    const struct fb_videomode *mode);
-	int			num_modes;
-	struct fb_videomode	*modes;
-
-	/* in mm: size of screen */
-	int			height;
-	int			width;
-};
-
-#endif