diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/misc/ti-st/st_kim.c | 37 |
1 files changed, 1 insertions, 36 deletions
diff --git a/drivers/misc/ti-st/st_kim.c b/drivers/misc/ti-st/st_kim.c index 7c14f8fd98db..5c99995f4eac 100644 --- a/drivers/misc/ti-st/st_kim.c +++ b/drivers/misc/ti-st/st_kim.c @@ -454,11 +454,6 @@ long st_kim_start(void *kim_data) if (pdata->chip_enable) pdata->chip_enable(kim_gdata); - /* Configure BT nShutdown to HIGH state */ - gpio_set_value(kim_gdata->nshutdown, GPIO_LOW); - mdelay(5); /* FIXME: a proper toggle */ - gpio_set_value(kim_gdata->nshutdown, GPIO_HIGH); - mdelay(100); /* re-initialize the completion */ INIT_COMPLETION(kim_gdata->ldisc_installed); /* send notification to UIM */ @@ -500,8 +495,7 @@ long st_kim_start(void *kim_data) * (b) upon failure to either install ldisc or download firmware. * The function is responsible to (a) notify UIM about un-installation, * (b) flush UART if the ldisc was installed. - * (c) reset BT_EN - pull down nshutdown at the end. - * (d) invoke platform's chip disabling routine. + * (c) invoke platform's chip disabling routine. */ long st_kim_stop(void *kim_data) { @@ -533,13 +527,6 @@ long st_kim_stop(void *kim_data) return -ETIMEDOUT; } - /* By default configure BT nShutdown to LOW state */ - gpio_set_value(kim_gdata->nshutdown, GPIO_LOW); - mdelay(1); - gpio_set_value(kim_gdata->nshutdown, GPIO_HIGH); - mdelay(1); - gpio_set_value(kim_gdata->nshutdown, GPIO_LOW); - /* platform specific disable */ if (pdata->chip_disable) pdata->chip_disable(kim_gdata); @@ -731,20 +718,6 @@ static int kim_probe(struct platform_device *pdev) /* refer to itself */ kim_gdata->core_data->kim_data = kim_gdata; - /* Claim the chip enable nShutdown gpio from the system */ - kim_gdata->nshutdown = pdata->nshutdown_gpio; - status = gpio_request(kim_gdata->nshutdown, "kim"); - if (unlikely(status)) { - pr_err(" gpio %ld request failed ", kim_gdata->nshutdown); - return status; - } - - /* Configure nShutdown GPIO as output=0 */ - status = gpio_direction_output(kim_gdata->nshutdown, 0); - if (unlikely(status)) { - pr_err(" unable to configure gpio %ld", kim_gdata->nshutdown); - return status; - } /* get reference of pdev for request_firmware */ kim_gdata->kim_pdev = pdev; @@ -780,18 +753,10 @@ static int kim_probe(struct platform_device *pdev) static int kim_remove(struct platform_device *pdev) { - /* free the GPIOs requested */ - struct ti_st_plat_data *pdata = pdev->dev.platform_data; struct kim_data_s *kim_gdata; kim_gdata = dev_get_drvdata(&pdev->dev); - /* Free the Bluetooth/FM/GPIO - * nShutdown gpio from the system - */ - gpio_free(pdata->nshutdown_gpio); - pr_info("nshutdown GPIO Freed"); - debugfs_remove_recursive(kim_debugfs_dir); sysfs_remove_group(&pdev->dev.kobj, &uim_attr_grp); pr_info("sysfs entries removed"); |