diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-trans.h')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-trans.h | 57 |
1 files changed, 43 insertions, 14 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-trans.h b/drivers/net/wireless/iwlwifi/iwl-trans.h index ff1154232885..b76532e238c1 100644 --- a/drivers/net/wireless/iwlwifi/iwl-trans.h +++ b/drivers/net/wireless/iwlwifi/iwl-trans.h @@ -221,14 +221,21 @@ struct iwl_device_cmd { /** * struct iwl_hcmd_dataflag - flag for each one of the chunks of the command * - * IWL_HCMD_DFL_NOCOPY: By default, the command is copied to the host command's + * @IWL_HCMD_DFL_NOCOPY: By default, the command is copied to the host command's * ring. The transport layer doesn't map the command's buffer to DMA, but * rather copies it to an previously allocated DMA buffer. This flag tells * the transport layer not to copy the command, but to map the existing - * buffer. This can save memcpy and is worth with very big comamnds. + * buffer (that is passed in) instead. This saves the memcpy and allows + * commands that are bigger than the fixed buffer to be submitted. + * Note that a TFD entry after a NOCOPY one cannot be a normal copied one. + * @IWL_HCMD_DFL_DUP: Only valid without NOCOPY, duplicate the memory for this + * chunk internally and free it again after the command completes. This + * can (currently) be used only once per command. + * Note that a TFD entry after a DUP one cannot be a normal copied one. */ enum iwl_hcmd_dataflag { IWL_HCMD_DFL_NOCOPY = BIT(0), + IWL_HCMD_DFL_DUP = BIT(1), }; /** @@ -348,14 +355,17 @@ struct iwl_trans; * @start_fw: allocates and inits all the resources for the transport * layer. Also kick a fw image. * May sleep - * @fw_alive: called when the fw sends alive notification + * @fw_alive: called when the fw sends alive notification. If the fw provides + * the SCD base address in SRAM, then provide it here, or 0 otherwise. * May sleep * @stop_device:stops the whole device (embedded CPU put to reset) * May sleep * @wowlan_suspend: put the device into the correct mode for WoWLAN during * suspend. This is optional, if not implemented WoWLAN will not be * supported. This callback may sleep. - * @send_cmd:send a host command + * @send_cmd:send a host command. Must return -ERFKILL if RFkill is asserted. + * If RFkill is asserted in the middle of a SYNC host command, it must + * return -ERFKILL straight away. * May sleep only if CMD_SYNC is set * @tx: send an skb * Must be atomic @@ -375,6 +385,8 @@ struct iwl_trans; * @write8: write a u8 to a register at offset ofs from the BAR * @write32: write a u32 to a register at offset ofs from the BAR * @read32: read a u32 register at offset ofs from the BAR + * @read_prph: read a DWORD from a periphery register + * @write_prph: write a DWORD to a periphery register * @configure: configure parameters required by the transport layer from * the op_mode. May be called several times before start_fw, can't be * called after that. @@ -385,7 +397,7 @@ struct iwl_trans_ops { int (*start_hw)(struct iwl_trans *iwl_trans); void (*stop_hw)(struct iwl_trans *iwl_trans, bool op_mode_leaving); int (*start_fw)(struct iwl_trans *trans, const struct fw_img *fw); - void (*fw_alive)(struct iwl_trans *trans); + void (*fw_alive)(struct iwl_trans *trans, u32 scd_addr); void (*stop_device)(struct iwl_trans *trans); void (*wowlan_suspend)(struct iwl_trans *trans); @@ -410,6 +422,8 @@ struct iwl_trans_ops { void (*write8)(struct iwl_trans *trans, u32 ofs, u8 val); void (*write32)(struct iwl_trans *trans, u32 ofs, u32 val); u32 (*read32)(struct iwl_trans *trans, u32 ofs); + u32 (*read_prph)(struct iwl_trans *trans, u32 ofs); + void (*write_prph)(struct iwl_trans *trans, u32 ofs, u32 val); void (*configure)(struct iwl_trans *trans, const struct iwl_trans_config *trans_cfg); void (*set_pmi)(struct iwl_trans *trans, bool state); @@ -438,12 +452,15 @@ enum iwl_trans_state { * Set during transport allocation. * @hw_id_str: a string with info about HW ID. Set during transport allocation. * @pm_support: set to true in start_hw if link pm is supported - * @wait_command_queue: the wait_queue for SYNC host commands * @dev_cmd_pool: pool for Tx cmd allocation - for internal use only. * The user should use iwl_trans_{alloc,free}_tx_cmd. * @dev_cmd_headroom: room needed for the transport's private use before the * device_cmd for Tx - for internal use only * The user should use iwl_trans_{alloc,free}_tx_cmd. + * @rx_mpdu_cmd: MPDU RX command ID, must be assigned by opmode before + * starting the firmware, used for tracing + * @rx_mpdu_cmd_hdr_size: used for tracing, amount of data before the + * start of the 802.11 header in the @rx_mpdu_cmd */ struct iwl_trans { const struct iwl_trans_ops *ops; @@ -457,9 +474,9 @@ struct iwl_trans { u32 hw_id; char hw_id_str[52]; - bool pm_support; + u8 rx_mpdu_cmd, rx_mpdu_cmd_hdr_size; - wait_queue_head_t wait_command_queue; + bool pm_support; /* The following fields are internal only */ struct kmem_cache *dev_cmd_pool; @@ -476,10 +493,6 @@ struct iwl_trans { static inline void iwl_trans_configure(struct iwl_trans *trans, const struct iwl_trans_config *trans_cfg) { - /* - * only set the op_mode for the moment. Later on, this function will do - * more - */ trans->op_mode = trans_cfg->op_mode; trans->ops->configure(trans, trans_cfg); @@ -499,16 +512,19 @@ static inline void iwl_trans_stop_hw(struct iwl_trans *trans, trans->ops->stop_hw(trans, op_mode_leaving); + if (op_mode_leaving) + trans->op_mode = NULL; + trans->state = IWL_TRANS_NO_FW; } -static inline void iwl_trans_fw_alive(struct iwl_trans *trans) +static inline void iwl_trans_fw_alive(struct iwl_trans *trans, u32 scd_addr) { might_sleep(); trans->state = IWL_TRANS_FW_ALIVE; - trans->ops->fw_alive(trans); + trans->ops->fw_alive(trans, scd_addr); } static inline int iwl_trans_start_fw(struct iwl_trans *trans, @@ -516,6 +532,8 @@ static inline int iwl_trans_start_fw(struct iwl_trans *trans, { might_sleep(); + WARN_ON_ONCE(!trans->rx_mpdu_cmd); + return trans->ops->start_fw(trans, fw); } @@ -650,6 +668,17 @@ static inline u32 iwl_trans_read32(struct iwl_trans *trans, u32 ofs) return trans->ops->read32(trans, ofs); } +static inline u32 iwl_trans_read_prph(struct iwl_trans *trans, u32 ofs) +{ + return trans->ops->read_prph(trans, ofs); +} + +static inline void iwl_trans_write_prph(struct iwl_trans *trans, u32 ofs, + u32 val) +{ + return trans->ops->write_prph(trans, ofs, val); +} + static inline void iwl_trans_set_pmi(struct iwl_trans *trans, bool state) { trans->ops->set_pmi(trans, state); |