ACPI: Add driver for the VIOT table

The ACPI Virtual I/O Translation Table describes topology of
para-virtual platforms, similarly to vendor tables DMAR, IVRS and IORT.
For now it describes the relation between virtio-iommu and the endpoints
it manages.

Three steps are needed to configure DMA of endpoints:

(1) acpi_viot_init(): parse the VIOT table, find or create the fwnode
    associated to each vIOMMU device. This needs to happen after
    acpi_scan_init(), because it relies on the struct device and their
    fwnode to be available.

(2) When probing the vIOMMU device, the driver registers its IOMMU ops
    within the IOMMU subsystem. This step doesn't require any
    intervention from the VIOT driver.

(3) viot_iommu_configure(): before binding the endpoint to a driver,
    find the associated IOMMU ops. Register them, along with the
    endpoint ID, into the device's iommu_fwspec.

If step (3) happens before step (2), it is deferred until the IOMMU is
initialized, then retried.

Tested-by: Eric Auger <eric.auger@redhat.com>
Reviewed-by: Eric Auger <eric.auger@redhat.com>
Signed-off-by: Jean-Philippe Brucker <jean-philippe@linaro.org>
Acked-by: Rafael J. Wysocki <rafael@kernel.org>
Link: https://lore.kernel.org/r/20210618152059.1194210-4-jean-philippe@linaro.org
Signed-off-by: Joerg Roedel <jroedel@suse.de>

1 files changed, 3 insertions, 0 deletions

diff --git a/drivers/acpi/Kconfig b/drivers/acpi/Kconfig
index eedec61e3476..3758c6940ed7 100644
--- a/drivers/acpi/Kconfig
+++ b/drivers/acpi/Kconfig
@@ -526,6 +526,9 @@ endif
 
 source "drivers/acpi/pmic/Kconfig"
 
+config ACPI_VIOT
+	bool
+
 endif	# ACPI
 
 config X86_PM_TIMER