Merge tag 'soc-drivers-6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc

Pull ARM SoC driver updates from Arnd Bergmann:
 "As usual, there are lots of minor driver changes across SoC platforms
  from NXP, Amlogic, AMD Zynq, Mediatek, Qualcomm, Apple and Samsung.
  These usually add support for additional chip variations in existing
  drivers, but also add features or bugfixes.

  The SCMI firmware subsystem gains a unified raw userspace interface
  through debugfs, which can be used for validation purposes.

  Newly added drivers include:

   - New power management drivers for StarFive JH7110, Allwinner D1 and
     Renesas RZ/V2M

   - A driver for Qualcomm battery and power supply status

   - A SoC device driver for identifying Nuvoton WPCM450 chips

   - A regulator coupler driver for Mediatek MT81xxv"

* tag 'soc-drivers-6.3' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc: (165 commits)
  power: supply: Introduce Qualcomm PMIC GLINK power supply
  soc: apple: rtkit: Do not copy the reg state structure to the stack
  soc: sunxi: SUN20I_PPU should depend on PM
  memory: renesas-rpc-if: Remove redundant division of dummy
  soc: qcom: socinfo: Add IDs for IPQ5332 and its variant
  dt-bindings: arm: qcom,ids: Add IDs for IPQ5332 and its variant
  dt-bindings: power: qcom,rpmpd: add RPMH_REGULATOR_LEVEL_LOW_SVS_L1
  firmware: qcom_scm: Move qcom_scm.h to include/linux/firmware/qcom/
  MAINTAINERS: Update qcom CPR maintainer entry
  dt-bindings: firmware: document Qualcomm SM8550 SCM
  dt-bindings: firmware: qcom,scm: add qcom,scm-sa8775p compatible
  soc: qcom: socinfo: Add Soc IDs for IPQ8064 and variants
  dt-bindings: arm: qcom,ids: Add Soc IDs for IPQ8064 and variants
  soc: qcom: socinfo: Add support for new field in revision 17
  soc: qcom: smd-rpm: Add IPQ9574 compatible
  soc: qcom: pmic_glink: remove redundant calculation of svid
  soc: qcom: stats: Populate all subsystem debugfs files
  dt-bindings: soc: qcom,rpmh-rsc: Update to allow for generic nodes
  soc: qcom: pmic_glink: add CONFIG_NET/CONFIG_OF dependencies
  soc: qcom: pmic_glink: Introduce altmode support
  ...

2 files changed, 129 insertions, 0 deletions

diff --git a/include/linux/firmware/qcom/qcom_scm.h b/include/linux/firmware/qcom/qcom_scm.h
new file mode 100644
index 000000000000..1e449a5d7f5c
--- /dev/null
+++ b/include/linux/firmware/qcom/qcom_scm.h
@@ -0,0 +1,125 @@
+/* SPDX-License-Identifier: GPL-2.0-only */
+/* Copyright (c) 2010-2015, 2018-2019 The Linux Foundation. All rights reserved.
+ * Copyright (C) 2015 Linaro Ltd.
+ */
+#ifndef __QCOM_SCM_H
+#define __QCOM_SCM_H
+
+#include <linux/err.h>
+#include <linux/types.h>
+#include <linux/cpumask.h>
+
+#include <dt-bindings/firmware/qcom,scm.h>
+
+#define QCOM_SCM_VERSION(major, minor)	(((major) << 16) | ((minor) & 0xFF))
+#define QCOM_SCM_CPU_PWR_DOWN_L2_ON	0x0
+#define QCOM_SCM_CPU_PWR_DOWN_L2_OFF	0x1
+#define QCOM_SCM_HDCP_MAX_REQ_CNT	5
+
+struct qcom_scm_hdcp_req {
+	u32 addr;
+	u32 val;
+};
+
+struct qcom_scm_vmperm {
+	int vmid;
+	int perm;
+};
+
+enum qcom_scm_ocmem_client {
+	QCOM_SCM_OCMEM_UNUSED_ID = 0x0,
+	QCOM_SCM_OCMEM_GRAPHICS_ID,
+	QCOM_SCM_OCMEM_VIDEO_ID,
+	QCOM_SCM_OCMEM_LP_AUDIO_ID,
+	QCOM_SCM_OCMEM_SENSORS_ID,
+	QCOM_SCM_OCMEM_OTHER_OS_ID,
+	QCOM_SCM_OCMEM_DEBUG_ID,
+};
+
+enum qcom_scm_sec_dev_id {
+	QCOM_SCM_MDSS_DEV_ID    = 1,
+	QCOM_SCM_OCMEM_DEV_ID   = 5,
+	QCOM_SCM_PCIE0_DEV_ID   = 11,
+	QCOM_SCM_PCIE1_DEV_ID   = 12,
+	QCOM_SCM_GFX_DEV_ID     = 18,
+	QCOM_SCM_UFS_DEV_ID     = 19,
+	QCOM_SCM_ICE_DEV_ID     = 20,
+};
+
+enum qcom_scm_ice_cipher {
+	QCOM_SCM_ICE_CIPHER_AES_128_XTS = 0,
+	QCOM_SCM_ICE_CIPHER_AES_128_CBC = 1,
+	QCOM_SCM_ICE_CIPHER_AES_256_XTS = 3,
+	QCOM_SCM_ICE_CIPHER_AES_256_CBC = 4,
+};
+
+#define QCOM_SCM_PERM_READ       0x4
+#define QCOM_SCM_PERM_WRITE      0x2
+#define QCOM_SCM_PERM_EXEC       0x1
+#define QCOM_SCM_PERM_RW (QCOM_SCM_PERM_READ | QCOM_SCM_PERM_WRITE)
+#define QCOM_SCM_PERM_RWX (QCOM_SCM_PERM_RW | QCOM_SCM_PERM_EXEC)
+
+extern bool qcom_scm_is_available(void);
+
+extern int qcom_scm_set_cold_boot_addr(void *entry);
+extern int qcom_scm_set_warm_boot_addr(void *entry);
+extern void qcom_scm_cpu_power_down(u32 flags);
+extern int qcom_scm_set_remote_state(u32 state, u32 id);
+
+struct qcom_scm_pas_metadata {
+	void *ptr;
+	dma_addr_t phys;
+	ssize_t size;
+};
+
+extern int qcom_scm_pas_init_image(u32 peripheral, const void *metadata,
+				   size_t size,
+				   struct qcom_scm_pas_metadata *ctx);
+void qcom_scm_pas_metadata_release(struct qcom_scm_pas_metadata *ctx);
+extern int qcom_scm_pas_mem_setup(u32 peripheral, phys_addr_t addr,
+				  phys_addr_t size);
+extern int qcom_scm_pas_auth_and_reset(u32 peripheral);
+extern int qcom_scm_pas_shutdown(u32 peripheral);
+extern bool qcom_scm_pas_supported(u32 peripheral);
+
+extern int qcom_scm_io_readl(phys_addr_t addr, unsigned int *val);
+extern int qcom_scm_io_writel(phys_addr_t addr, unsigned int val);
+
+extern bool qcom_scm_restore_sec_cfg_available(void);
+extern int qcom_scm_restore_sec_cfg(u32 device_id, u32 spare);
+extern int qcom_scm_iommu_secure_ptbl_size(u32 spare, size_t *size);
+extern int qcom_scm_iommu_secure_ptbl_init(u64 addr, u32 size, u32 spare);
+extern int qcom_scm_iommu_set_cp_pool_size(u32 spare, u32 size);
+extern int qcom_scm_mem_protect_video_var(u32 cp_start, u32 cp_size,
+					  u32 cp_nonpixel_start,
+					  u32 cp_nonpixel_size);
+extern int qcom_scm_assign_mem(phys_addr_t mem_addr, size_t mem_sz,
+			       unsigned int *src,
+			       const struct qcom_scm_vmperm *newvm,
+			       unsigned int dest_cnt);
+
+extern bool qcom_scm_ocmem_lock_available(void);
+extern int qcom_scm_ocmem_lock(enum qcom_scm_ocmem_client id, u32 offset,
+			       u32 size, u32 mode);
+extern int qcom_scm_ocmem_unlock(enum qcom_scm_ocmem_client id, u32 offset,
+				 u32 size);
+
+extern bool qcom_scm_ice_available(void);
+extern int qcom_scm_ice_invalidate_key(u32 index);
+extern int qcom_scm_ice_set_key(u32 index, const u8 *key, u32 key_size,
+				enum qcom_scm_ice_cipher cipher,
+				u32 data_unit_size);
+
+extern bool qcom_scm_hdcp_available(void);
+extern int qcom_scm_hdcp_req(struct qcom_scm_hdcp_req *req, u32 req_cnt,
+			     u32 *resp);
+
+extern int qcom_scm_iommu_set_pt_format(u32 sec_id, u32 ctx_num, u32 pt_fmt);
+extern int qcom_scm_qsmmu500_wait_safe_toggle(bool en);
+
+extern int qcom_scm_lmh_dcvsh(u32 payload_fn, u32 payload_reg, u32 payload_val,
+			      u64 limit_node, u32 node_id, u64 version);
+extern int qcom_scm_lmh_profile_change(u32 profile_id);
+extern bool qcom_scm_lmh_dcvsh_available(void);
+
+#endif
diff --git a/include/linux/firmware/xlnx-zynqmp.h b/include/linux/firmware/xlnx-zynqmp.h
index b09f443d3ab9..0e4c70987e6a 100644
--- a/include/linux/firmware/xlnx-zynqmp.h
+++ b/include/linux/firmware/xlnx-zynqmp.h
@@ -79,6 +79,10 @@
 #define EVENT_ERROR_PSM_ERR1	(0x28108000U)
 #define EVENT_ERROR_PSM_ERR2	(0x2810C000U)
 
+/* ZynqMP SD tap delay tuning */
+#define SD_ITAPDLY	0xFF180314
+#define SD_OTAPDLYSEL	0xFF180318
+
 enum pm_api_cb_id {
 	PM_INIT_SUSPEND_CB = 30,
 	PM_ACKNOWLEDGE_CB = 31,